Review of B and W Gooseneck - Below the Bed - BWGNRK1320 Video

No, they will not but I have a custom fit set that does. They are the Curt item #C16427-204. This set of rails is industry standard so they will work great with your Curt Q20 Slider. The brackets are custom fit and install in pre-existing holes in…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

The base dimensions of the B and W Companion Flatbed Gooseneck-to-5th-Wheel Trailer Hitch Adapter #BWRVK3050 is 18 x 18-inches and will install it in an opening that measures 20 x 20 x 4-inches deep. The recessed opening cannot be more than 4-inches…

The B&W Companion Gooseneck-to-5th-Wheel Trailer Hitch Adapter part #BWRVK3500 that you referenced has a vertical adjustment from 16-1/4" - 18-1/4". Please also keep in mind that the base will require a 36" long x 30-1/2" wide…

On the B&W #BWRVK3370 Companion 5th Wheel Hitch, the distance from the rear puck connector to the back edge of the hitch is 7-1/2" and I have attached a graphic illustrating this. In your truck bed, go to the rear puck mounts and from the…

The post of the #BWRVK3050 Companion 5th Wheel Hitch for flat bed trucks that installs into their Turnover Ball hitch is 4-1/8 inches long, and the slot in the post measures 3-1/2 inches long, as shown in the provided photo. The #BWRVK3050 is meant…

If your CM Truck Bed is their ER model my contact at CM said that if it is a later model the trough where the ball sits should be about 20-inches wide and this will be enough room to use the B&W Companion 5th wheel adapter #BWRVK3050. This hitch…

The B and W Flat Bed Fifth Wheel Hitch part #BWRVK3050 will set 10-1/2 inches above the deck height of the flat bed truck it is installed in. I attached a review video for this hitch for you to check out as well.

At one point the B and W Companion Flat Bed to Gooseneck Fifth Wheel Hitch part #BWRVK3050 that you referenced had lower capacities but I confirmed that the correct capacities for this hitch are 25k total trailer weight and 6,250 lbs pin weight.

The B&W Companion Flatbed Gooseneck-to-5th-Wheel Trailer Hitch Adapter - Dual Jaw - 25,000 lbs #BWRVK3050 is intended to be used only with the B&W Underbed Gooseneck System, so any use outside of that would void the manufacturer's…

The problem is the Flatbed Fifth Wheel Hitch part #BWRVK3050 has a shank that will be too tall to allow the hitch to rest on the bed of the truck since flat bed goosenecks are recessed and even if the hitch would fit the bed the head height would be…

Typically a suspension bolt will be measured by the shaft of the bolt not including the head, since the head of the bolt isn't used in mounting the springs. The shackles are 3-3/4" long x 1-1/2" tall overall and the bolt holes are…