B and W Ball Mounts - Adjustable Ball Mount - BWTS10048B Review Video

The B&W Silencer Pad #BWTS35020 is intended to be placed on the shank of one of their Tow & Stow Multi-Ball Mounts like #BWTS10048B so that it acts like a gasket between the collar on the end of the hitch's receiver tube and the…

The B&W Tow & Stow 3-Ball Mount part #BWTS30048B is designed for a 3" receiver tube opening therefore if this is what you have on your 2006 Ford F-250 then yes, it will work for you. However, if I had to guess I would say that you have a…

I would be happy to recommend everything you need to flat tow your 2021 Ford F-150. I recommend the Blue Ox Base Plate Kit #BLU33FR which is confirmed to fit your vehicle and will pair up perfectly with the Blue Ox Avail Tow Bar #BX7420. Since the…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

The B&W Tow & Stow 3-Ball Mount part #BWTS10048B has a distance from the center of the hitch pin hole to the back edge of the vertical upright of 3" and 4-1/8" respectively. I have attached a photo below to assist.

I went to the warehouse to take some measurements and found that from the top of the receiver to the bottom of the 2-5/16" hitch ball was approximately 10-1/2" for the B&W Tow & Stow 3-Ball Mount with 5" of drop #BWTS10048B…

The distance from the top of the shank to the bottom of the platform on the B&W Tow & Stow 3-Ball Mount part #BWTS10048B while in the stowed position is 8-1/2". I am not sure where you were measuring from but if you measure from the top…

For your standard height trucks and trailers, the B&W Tow & Stow 3-Ball Mount - 2" Hitch - 5" Drop, 5-1/2" Rise - 10K - Black #BWTS10048B will work very well for both of your trucks. This will not only work well with all 5 of…

Yes, all pins on the B&W Tow & Stow 3-Ball Mount part #BWTS10048B must be used for operation. If you're looking for security, there is a kit designed for this ball mount that comes with matching locks for all four total pins, the…

Because of the large span required to secure the ball mount of the B&W Tow and Stow 3-Ball Mount #BWTS10048B, the Master Lock Trailer Hitch Receiver Lock #1480DAT will not work to secure the ball mount to the shank. The span of the #1480DAT hitch…

The best way to pick out a weight distribution system is to base it off of the loaded tongue weight of the setup when it is loaded and ready to tow, this figure also includes the weight of any cargo behind the rear axle of the tow vehicle. I attached…

The actual height of a vehicle's hitch will depend on several things including the age and condition of the suspension, the wheel/tire size, the condition of the tires (are they new or do they have 40K miles on them) as well as the passenger and…