Andersen Ball Mounts AM3424 Review Video

For the Rapid Hitch Andersen Adjustable Ball Mount part #AM3410 we have replacement ball sets like part #AM3424 that has the same size balls or part #AM3425 for a 1-7/8 inch and 2 inch hitch ball size.

The fuses for the 7-way trailer connector on your 2013 Ford F-150 are in the power distribution center as follows: Trailer Tow Brake Control #17 30 Amp Fuse Trailer Tow Battery Charge #21 20 Amp Fuse Trailer Tow Back-Up Lamp #43 15 Amp Fuse Trailer…

Is it a disc caliper like the part #K71-636-00 or is it a drum brake component? I believe you are looking for the #K71-636-00 but wanted to make sure.

There are not many differences between a welded and forged weight distribution shank in regards to practicality. They both pass the same DOT standards and meet the maximum 15,000 lb weight capacity requirement. The forged shanks started to become…

The Performance Tool Vehicle and Trailer Aligner part #PTW1276 would not attach directly to the hitch ball on the Rapid Hitch Adjustable, Aluminum Ball Mount Kit part #AM3405 because the top is made of nylon which is not magnetic. However, the…

To remove the existing hitch ball combo on your Andersen Rapid Hitch Ball Mount like #AM3411, you will first need to remove the internal pin that goes through the ball housing and hitch ball. The small pin has a threaded hole in it. This lets you…

The Ultimate Trailer Jack - A-Frame - Topwind - 27-1/2" Lift - 2,000 lbs part #322-RDJ-2K will not sit flush with the collar even when unpinned. The jack locks into place automatically. There will be about 7-1/4" from the collar to the top…

In order to remove the existing hitch ball combo on your Andersen Rapid Hitch Ball Mount like #AM3411, you will first need to remove the internal pin that goes through the ball housing and hitch ball. The small pin has a threaded hole in it, through…

The diameter of the Replacement Internal Pin part #AM3440 that you referenced is 5/8 of an inch.

There is a pin that keeps the hitch ball(s) in place on the platform. If you remove the platform of your Rapid Hitch adjustable ball mount then you can see and easily remove the pin to remove the hitch ball(s). I have linked a review video for the…

As you can see by the photo I provided, both of the trailer balls used on the Andersen Rapid Hitch are constructed of a single piece. It is not possible to remove one ball.

There is a re-keying kit we offer for the ball mount part #DTALBM6625 it is part #DTLBM02RK. It comes with new lock cores and a wrench that allows you to remove the lock cores. I attached an install video for the kit that will walk you through the…