Replacement Breakaway Lever Assembly for Titan Model 10 Surge Brake Coupler

Question

Question:

I have a Titan Model 10 brake coupler. Is there a replacement break-away lever assembly available?

asked by: Dalekarwowski

0

Expert Reply:

We do indeed offer a replacement breakaway lever assembly for the Titan Model 10, the part number is # T1054100.

expert reply by: Mike L

0

Answer 1

The correct replacement breakaway lever for your Titan Model 6 Zinc-Plated Brake Actuator part #T4747200 is the Replacement Breakaway Lever with Pin for Titan Model 6 Actuators part #T4594100. In regards to installation, this will be up to you as…

view full answer...

Answer 2

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

view full answer...

Answer 3

Begin by removing the master cylinder cap and fill the reservoir to three quarters full with DOT-3 brake fluid. DO NOT allow brake fluid to contact painted surfaces since it will damage the finish. Wipe up any spills immediately and wash the area…

view full answer...

Answer 4

Hi Michael, While we don't have any way of knowing what winch stand goes on any specific trailer, it is possible we have an option for a winch stand for your Karavan trailer. The only option we have for a stand is the CE Smith Winch Stand…

view full answer...

Answer 5

The best trailer coupler lock for your Titan Model 10 Brake Actuator #T2478100 is the Blaylock EZ Lock Trailer Coupler Lock #BLTL-33-40D because it locks your actuator with a stainless steel padlock that has a hardened steel shackle and busting…

view full answer...

Answer 6

Go ahead and email me back with the picture of what you have and I can see if we can help. Worst case scenario you'd have to replace the coupler.

view full answer...

Answer 7

For your Dico Model 10 actuator the Titan replacement Inner Slide Assembly #T2478300183 is going to be exactly what you will need. It is recommended that you install new slide bearings as well so for that you would need part #T1020900. I attached a…

view full answer...

Answer 8

Although we don't have a kit that includes the bearings/seal all in one package, you can certainly obtain the parts separately. You'll need: #25580 inner bearing and its #25520 race #LM67048 outer bearing and its #LM67010 race #21325 Double…

view full answer...

Answer 9

I recommend replacing your current surge brake coupler using either using the Demco Hydraulic Brake Actuator for Disc #DM8104311 or Drum #DM8102511 brakes. I prefer these couplers as they have a Zinc finish which best resists corrosion.

view full answer...

Answer 10

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...