Stainless Steel Alloy of the Continuous Hinge part # SH300

Question

Question:

What alloy of S.S. is this model hinge made of?

asked by: Zed B

0

Expert Reply:

The stainless steel allow of the Hinge part # SH300 that you referenced is 304.

expert reply by: Jameson C

0

Answer 1

All of our piano hinges like the 3" Wide #SH300 do not come pre-drilled. We do not carry any which are pre-drilled.

view full answer...

Answer 2

A piano hinge like the part #SH300 would work great for you to allow you to fold your aluminum ramp in half. This hinge is stainless steel too so it won't rust. You might put some thin rubber between the hinge and the ramp to prevent galvanic…

view full answer...

Answer 3

I wish we had a hinge kit that had hole drilled in it already but none of the ones we offer do and we do not have any screw kits designed specifically for them either.

view full answer...

Answer 4

The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still cover most of the area you need it…

view full answer...

Answer 5

From our experiences the Harbor Freight trailers like yours have a hub bore that requires a cap or Bearing Buddy that measures 2.047 inches like the #BB2047 you referenced. We don't have a standard cap that fits this size so the Bearing Buddy is…

view full answer...

Answer 6

M12-1.5 and 1/2"-20 threads are not going to be interchangeable. The diameter of an M12 thread is only going to be 0.4724" while 1/2" threads are going to be 0.500" in diameter. We currently only have 1/2"-20 Lug Nuts…

view full answer...

Answer 7

On oil bath hubs the seals are different than standard grease seals. The correct replacement for what you have is #91030. Unitized oil seals like this have a part that stays fixed and a part that rotates with the hub for optimum leak protection. I…

view full answer...

Answer 8

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 9

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 10

It sounds like the 2022 Chevy Silverado 3500 you are getting has the short bed. In that case, yes, you definitely want the sliding 5th wheel hitch for clearance. The good news is you will not need to purchase the entire B&W Companion #BWRVK3775.…

view full answer...

Answer 11

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 12

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Stainless Steel Alloy of the Continuous Hinge part # SH300

Product Page this Question was Asked From

Continue Researching