Piano Hinge Recommendation for a Aluminum Ramp so that It can Fold
Question:
Im looking to convert my aluminum ramp into a bifold. Do you have aluminum hinges?
asked by: Tony
0
Expert Reply:
A piano hinge like the part # SH300 would work great for you to allow you to fold your aluminum ramp in half. This hinge is stainless steel too so it won't rust. You might put some thin rubber between the hinge and the ramp to prevent galvanic corrosion.
This hinge is 3 inches wide and 6 feet long.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
3" Wide Continuous Hinge - 6' Long - Stainless Steel
- Trailer Door Hinges
- Piano Hinge
- Continuous Hinge
- Stainless Steel
- 72 Inch Long
- 1/4 Inch Diameter
- 3 Inch Wide
- Bolt-On - No Pre-Drilled Holes
- Weld-On
- Polar Hardware
more information >
Continue Researching
- Q&A: How To Properly Measure Slipper Springs For Your Trailer's Leaf Sping Suspension
- Q&A: Weight Distribution System Compatible With Lifted Truck
- Q&A: Which Piano Hinge will Work the Best on a Trailers Ramp Extension
- Q&A: Converting Swing Open Trailer Door to a Ramp Door to Load a Motorcycle
- Q&A: Tools Needed to Install Enclosed Trailer Transition Plate
- Q&A: Recommended 6 Foot Long Continuous Door Hinge for a Trailer
- Article: Determining Trailer Tongue Weight
- Q&A: Replacement Breakaway Pin for Demco SBS Air Force One Supplemental Breakaway
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Calculating Portable Generator Power Needs
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Rooftop Cargo Carriers