Troubleshooting No Power to Battery Feed on Trailer Connector on 2014 Chevrolet Silverado
Question:
2014 silverado, The 30 amp fuse under rthe hood went bad, replaced it and still no power to feed the battery in the trailer.
asked by: Dave
Expert Reply:
If your Silverado's +12V trailer power feed did work properly at some point but then blew a fuse, I suggest you carefully inspect the trailer connector and wiring for any condition that could cause a short. Look for worn or cracked insulation on the 12V circuit's wiring; also check for a secure ground at the main vehicle and trailer connectors. A circuit tester like # PTW2993 will allow you to test the 12V feed at all connection points.
If the power feed has not functioned at all then you may still need to make some wiring connections within the engine compartment to activate the trailer power circuit.
The linked photo and article detail this process of the connecting the subject wiring and stud by the power distribution box in the engine compartment. Refer to the section of the article entitled 'Finalizing Connections for the Brake Controller'.
Also, please note that a 40-amp fuse is usually required to handle the trailer's power draw.
Products Referenced in This Question
Product Page this Question was Asked From
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Wiring
- Shop: Trailer Hitch
- Video: Trailer Wiring Harness Installation - 2017 Chevrolet Express Van 55540
- Video: Trailer Hitch Installation - 2014 Chevrolet Express Van - Curt
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class IV - 2"
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class V XD - 2"
- Shop: Bulldog Round, A-Frame Jack - Sidewind - 13" Lift - 3,000 lbs
- Q&A: Troubleshooting No Power At The Factory Trailer Plug
- Shop: Brake Controller
- Video: Best 2013 Chevrolet Express Van Trailer Wiring Options
- Video: Best 2013 Chevrolet Express Van Trailer Hitch Options
- Q&A: Recommended Trailer Wiring Harness for 2013 Chevy Express 3500
- Q&A: Will Hopkins 7- and 4-Pole Trailer Connector Socket # HM40975 Fit 2011 Jeep Grand Cherokee
- Q&A: Replacement 7-Way Recommendation for a 2004 Chevy Silverado 1500
- Q&A: Replacement 7 and 4-Way Recommendation for 2005 Ford F-250
- Video: Bulldog Round A-Frame Jack Review BD1550101344
- Shop: Hopkins Plug-In Simple Wiring Harness for Factory Tow Package - 4-Pole Flat Trailer Connector
- Shop: 7-Way RV Upgrade Kit for Trailer Brake Controller Installation - 12 Gauge Wires
- Video: Bulldog Trailer Jack - A-Frame Jack - BD1550101344 Review
- Shop: RV Bike Racks
- Video: Curt T-Connector Vehicle Wiring Harness Installation - 2018 Volkswagen Atlas
- Article: Trailer Wiring Diagrams
- Q&A: Troubleshooting Factory Trailer Wiring that has No Power
- Q&A: No Power At Vehicle Connector And Trailer Battery Not Charging With Truck Running On Dodge Ram
- Shop: Vehicle Seat Covers
- Search Results: trailer hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: hitch