Can Continuous Steel Piano Hinge # H300 be Cut to Length Needed

Question

Question:

I am make cabinets for my enclosed trailed and going to use the continuous hinge on the doors and need to knew if the continuous hinge can be CUT to the size I need them? THANK YOU

asked by: George B

1

Helpful Expert Reply:

Yes, you can cut the hinge, # H300, to the size you need with the proper equipment. An angle grinder with a cutting wheel would be a good choice to cut the hinge. We have other hinge options if you are interested. I have linked them for you.

expert reply by: Michael H

1

Answer 1

Here is a list of the tools needed to install the etrailer Enclosed Trailer Transition Plate #e32JR: - Tape Measure - Drill - Hex Drive Socket Adapter - 10mm Socket - 13mm Socket I have also added a link below to the instructions of the #e32JR for…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

I can end this debate for you real fast! Trailer tires, which will have an ST in front of the size, should always be inflated to the maximum psi indicated on the tire. Trailer tires usually do not have a recommended and maximum psi indication so I am…

view full answer...

Answer 5

The etrailer Enclosed Trailer Transition Plate #e32JR will work very well for loading and unloading motorcycles. It has a working load limit of 1,000 lbs so even with your 850 lb bike, you are well within parameters weight capacity wise. Especially…

view full answer...

Answer 6

Yes you are - all 5th wheel hitches are going to require some type of rails in order to be used. So you'd need #DM8552016-71 for your 2006 Dodge Ram.

view full answer...

Answer 7

I spoke with Fogatti about your Fogatti RV Tankless Water Heater #LSB44FR giving an E8 code even though your exhaust isn't clogged and they recommend that you try to adjust the HC parameter values.

view full answer...

Answer 8

The best fixed fifth wheel hitch we offer for your 2019 Ford F-250 with the factory fifth wheel prep package is the USA B and W Companion Hitch part #BWRVK3200. The Companion hitches are widely regarded as the best fifth wheel hitches on the market…

view full answer...

Answer 9

You're right, the mounting bracket is unique (in a good way) for the Curt TriFlex NEXT Trailer Brake Controller #C24VV. The bracket is smaller and all you do is put the included adhesive tape on the bracket and stick it wherever you like under…

view full answer...

Answer 10

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 11

I have included an image below with the measurements for the openings on the Rail Kit #C16411-204 which fits your 2017 Chevrolet Silverado 2500HD. As long as these match both left to right and front to back for the center mounting points on your RBW…

view full answer...

Answer 12

Though the Firestone Ride-Rite Red Label Extreme Duty Air Helper Springs #F2709 will offer you more support when fully loaded, they will also affect your ride a lot more when not loaded. Even at the lowest setting (5 psi). I really only recommend…

view full answer...

Can Continuous Steel Piano Hinge # H300 be Cut to Length Needed

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching