Replacement Slide Out Motor for Arctic Fox 27-5 368807

Question

Question:

I have a Lippert slide motor on my Artic Fox 27-5 fifth wheel that is a year and a half old and it has gone out. Part number is 368807. Can you tell me the replacement for that as I can not find that part number in your system. Thx

asked by: Lyndwood L

0

Expert Reply:

Hey Lyndwood, based on the slide motor part number you found on your Arctic Fox 27-5 368807 the correct replacement is the part # LC368190.

expert reply by: Jameson C

0

Answer 1

From the research I have done, I believe the slide out on your Northwood Arctic Fox Travel Trailer uses Replacement Gear Motor Assembly for Lippert Electric Slide-Out, #LC386322.

view full answer...

Answer 2

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 3

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 4

The part you referenced 127194TB is a double-lip seal with an inner diameter of 1.274-inches and an outer diameter of 1.983-inches. The available seal nearest to those dimensions that we offer is part #RG06-010, which is a double-lip seal sold as a…

view full answer...

Answer 5

A TCM double-lip grease seal number 127194 has an inner diameter of 1.274-inches and an outer diameter of 1.983-inches according to my research. The available grease seal nearest to those dimensions that we offer is part #RG06-010, which is a…

view full answer...

Answer 6

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 7

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Answer 8

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 9

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

Answer 10

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

view full answer...

Answer 11

Typically, when the outside edges of a tire are showing wear its because the tires are under-inflated. The solution is to inflate the tires to the maximum pressure listed on the sidewall. Now if the outside of tires have what looks like gouges are…

view full answer...

Answer 12

The Blue Ox systems cannot be moved back that far but we do have the perfect system for you. Take a look at the Reese SC weight distribution systems linked to the right (minus the ones that say Light Duty). These systems have narrow brackets that can…

view full answer...

Replacement Slide Out Motor for Arctic Fox 27-5 368807

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching