Is KR10D a Single Rotor or a Set of Two

Question

Question:

Im looking at Kodiak 10 slip on rotor . Is this a set of 2 or a single rotor?

asked by: Yorick

0

Expert Reply:

The Kodiak 10" Rotor - 5 on 4-1/2 - Dacromet - 3,500 lbs # KR10D is sold in a quantity of one, so it is a single rotor.

To get two you would just enter "2" in the "Quantity" box on the product page of the # KR10D.

expert reply by: Kyle S

0

Answer 1

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 2

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

Answer 3

The squeaking noise on your trailer is probably coming from the joints in the suspension creating metal to metal friction. So, unless your original Equa-Flex Cusioned Equalizers are damaged or corroded, what will make the biggest difference is to…

view full answer...

Answer 4

I was able to find the exact replacement amber (1A-S-20A) and red (1A-S-20R) lenses. I did a Google search on kaper2 (or Kaper II), and found replacement lenses. Their replacement lenses are shown as measuring 4 inches long, by 2 inches wide by 3/4…

view full answer...

Answer 5

We offer replacement brake shoes for 10 x 1-1/2- and 10 x 2-1/4-inch electric drum brakes but no longer for the 1-3/4-inch width you reference. Dexter part #bp04-065 you referenced is a set of replacement brake shoes for electric trailer brakes…

view full answer...

Answer 6

I do have an option for you but we don't carry any braking assemblies that are 10" diameter x 1-3/4" wide. These are an oddball size and would be best replaced with something more modern so you can access replacement parts if needed.…

view full answer...

Answer 7

On single axle trailers typically you put the hanger spacing right at 1/4 of an inch shorter than the leaf spring length from eye to eye center. So if you were using the leaf spring part #e54SR that you referenced which measures 25-1/8 inches long…

view full answer...

Answer 8

The trick here is to get as close as possible. If you are talking about less than 2 inches or so, there is nothing to worry about. Having the trailer tongue a bit too high is preferable to it being too low. You may be a good candidate for an…

view full answer...

Answer 9

You'll just need to run to your local hardware store and grab a supply line to connect your Dometic 310 Part-Timer RV Toilet #DOM37FR to your water inlet. I had to do the same in the attached video below when the new toilet I was installing had…

view full answer...

Is KR10D a Single Rotor or a Set of Two

Product Page this Question was Asked From

Continue Researching