Timbren Rear Suspension Enhancement For a 2023 Ram 3500 Dually Long Bed

Question

Question:

What part number Timbren for 2023 ram 3500 dually with 8ft bed

asked by: Dan M

0

Expert Reply:

The Timbren Rear Suspension Enhancement System # TDR3500CA is the standard rating Timbren springs for your 2023 Ram 3500 Dually with an 8' bed. Do note these will not fit if you have the factory air suspension option.

We also have the Severe Service Kit # T94VR which are rated for trucks which always carry heavy loads. So if you are only using the truck with towing heavy loads or installing a service bed these are the best option.

expert reply by: Bud M

0

Answer 1

The correct Timbren Rear Suspension Enhancement System for a 2016 Ram 3500 with truck bed camper is part #TDRTT3500D as these were actually designed for this exact purpose. The other option part #TDR3500CA is just designed for standard towing…

view full answer...

Answer 2

The Timbren #T94VR is a fit for 2WD and 4WD models of the 2020 Ram 3500 Cab/Chassis, as confirmed by Timbren. This system is ideal for heavy duty applications like tow trucks or trucks that carry slide-in campers or salt spreaders. If you click the…

view full answer...

Answer 3

I checked with Curt and they do show the Curt Trailer Hitch Receiver part #C13233 as a fit for a 2022 Volvo XC90 All Models which includes the Recharge.

view full answer...

Answer 4

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 5

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Answer 6

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

Answer 7

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 8

It really just depends on what the wires are for. Most likely you have several ground wires among the 8 as well as a couple running light circuits in there as well. You just have to run all of the wires to the correct circuits. The 4-way wiring of…

view full answer...

Answer 9

A 4-way trailer connector will have four functions which means it will also have four wires for the exception of wishbone harnesses. These four functions are ground, tail light, right turn, and left turn. The ground function will usually be…

view full answer...

Answer 10

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 11

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 12

Yes, you are correct. In order to correctly take this measurement you will need to measure from the center of the spindle to the center of the main axle tube. I have included a picture for reference.

view full answer...

Timbren Rear Suspension Enhancement For a 2023 Ram 3500 Dually Long Bed

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching