Timbren Rear Suspension Enhancement System Installation - 2009 Dodge Ram Pickup Video

The Timbren Suspension system that you will need for your 2011 Dodge Ram 3500 is part #TDR3500CA. All the hardware needed for installation and instructions will be included with the Timbren suspension enhancement kit. Installing the Timbren systen…

The Dexter 2-Tang Clevis #T1807800 has mounting holes that will line up with the BulletProof Hitches 2-Ball Mount for 2-1/2" Hitches #MD254, but the Clevis uses 3/4" pins while the BulletProof shank uses 5/8" pins for the ball mount.…

For your 2019 Ram 3500 single rear wheel the correct fitting Timbren kit is part #TDR3500CA that you referenced. Timbren has confirmed for us that this does fit your truck. It fits a few years of the Ram trucks which might be why you've seen…

The Timbren #TDR3500CA Aeon springs are a fit for your truck. According to Timbren, there was a manufacturing run that had weld spatter on the threads, but this was an isolated incident that occurred some time ago. The problem has been taken care of…

For your 2003 Chevy Silverado BullRing has the BullRing Retractable Tie-Down Anchors for Truck Bed Stake Pockets - Raised Fit - 1,000lbs - Qty 4 #BU85FR or the #BU25FR for a quantity of 6. For your 2019 Ram Bullring has a stainless steel flush-fit…

I will be happy to provide some dimensions for you for the Timbren rear suspension enhancement system, #TDR1500DQ, for your 2012 Ram 1500. First, the height of the spring by itself is 5-1/2 inches. The springs have a diameter of 4 inches. I have…

Great question. Suspension Enhancement Sytems (SES) are intended to assist suspension in good working condition, but will not correct any bowing in your axle or increase the towing capacity of your vehicle. Assuming your vehicle suspension is in good…

The best option would be a fold out step setup for your horse trailer where you need a height of 26 inches. The Lippert manual pull out step part #LC432690 would be a fantastic option. When it's out you have 25 inches from the mounting bracket to…

The Timbren Rear Suspension Enhancement System, part #TDR3500CA is a confirmed fit for your 2015 Ram 3500. The system does come with a 1 inch spacer just in case you need additional length. I have attached a drawing that shows the clearance that you…

The correct Timbren suspension kit for your 2014 Ram 3500 4x4 is the kit part #T94VR which we know is a confirmed fit for your truck and will work well.

Technically you can add any Manual Pull-Out Step like #LC432678 to your trailer. You may need to also add outriggers #LC301704 to the frame in order to get the step in the right position and if you can't attach it reasonably to the desired…

Since your factory hitch is bolted on and not welded on the correct Torklift hitch is the #TLD1102 and not the part.