How to Determine if Advent Air ACDOM150 Will FIt Roadtrek Motorhome

Question

Question:

will this a/c fit on a 2022 Roadtrek on a 2021Promaster chassis

asked by: Bill H

0

Expert Reply:

I can tell you how to determine the fit of the Advent Air Replacement RV Air Conditioner for Dometic Setup # ACDOM150 on your Roadtrek motorhome, but we don't have a way of knowing specifically what AC unit you currently have.

So you'll need to check the control center model number on your Dometic AC and if you have the Analog model number 3107541.009 and 3107541.017, or Comfort Control Center model number: 3109226.005 you can use the # ACDOM150.

expert reply by: Kyle S

0

Answer 1

Nope, all you may need is the 6-to-9 pin adapter #ACCOLKIT if you find your current Dometic Dup Therm uses a 9 pin connrector. The Advent #ACM150 will work with your existing plenum and thermostat, as you're just replacing the roof top unit and…

view full answer...

Answer 2

The Advent Air RV Air Conditioner part #ACM135 is designed as a direct replacement for Dometic units with six wire plugs. If you have a nine wire plug then you won't be able to reuse the existing distribution box and you'll need to swap yours…

view full answer...

Answer 3

The Replacement Single Zone Thermostat for Dometic RV Air Conditioners #DMC79FR is a single zone 3 wire thermostat like the one you are describing. I have attached the wiring diagram for this thermostat and the control box below for your reference.

view full answer...

Answer 4

I attached a diagram for the thermostat wiring of the Advent AC Unit part #ACM135B for you to check out.

view full answer...

Answer 5

If you have the ACTH12 then you should also have the Air Distribution Box #ACRG15 which will have a control box for your wiring from the rooftop unit #ACM135 and the thermostat. This air distribution box and thermostat will wire up exactly the same…

view full answer...

Answer 6

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 7

The Tekonsha OEM Vehicle Wiring Harness #22121 that you referenced includes all the wiring and parts necessary to install a fully functional 7-Way connector and trailer brake controller. The included brake controller harness is compatible with and…

view full answer...

Answer 8

Hi Robert, If you're just wanting to replace the condenser unit on the rooftop and retain use of your current air distribution box and thermostat then you'll just need to determine what style connector your current unit has. If you remove the…

view full answer...

Answer 9

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Answer 10

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

view full answer...

Answer 11

Hey William, so the Advent Air AC unit part #ADV64FR would be a solid 15k BTU rated replaced for your setup. It is designed for ducted applications like you'd need as well. This also will wire right up to Advent and Dometic setups but if you have…

view full answer...

Answer 12

You have it right so far, the 4-way connector is just as you have stated. Remember that Yellow has a L in it so that is the left side brake/turn signal and green has a R in it so that is the right side brake/turn signal. The colors for wiring a 7-way…

view full answer...

How to Determine if Advent Air ACDOM150 Will FIt Roadtrek Motorhome

Product Page this Question was Asked From

Continue Researching