Will The Phoenix Faucets Pop Up Drain Assembly # PF282010 Fit LaSalle Bristol Sink # 34416166PW?

Question

Question:

Will this fit the LaSalle Bristol RV sink that you sell? It has a 1-1/8” diameter drain opening. Thanks.

asked by: Jeff

0

Expert Reply:

The LaSalle Bristol Single Bowl RV Bathroom Sink # 34416166PW you found will not accept the Phoenix Faucets Pop Up Drain Assembly # PF282010 as it has the the drain assembly molded into the sink itself. The Phoenix drain is designed to fit a sink like the Better Bath # LC209635 which has only has a hole in the bottom in which the Phoenix drain will compress onto.

expert reply by: Bud M

0

Answer 1

The closest RV microwave we carry to match the dimensions of your Samsung MR1032UBC microwave is the Greystone Standard RV Microwave w/ Trim Kit #324-000105. The trim kit will cover the width of your your opening but will not completely cover the…

view full answer...

Answer 2

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 3

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 4

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for your…

view full answer...

Answer 5

To see all of the correct wheel and tire combos you'd need check out the link I attached. The option I would recommend is the part #TA43RR which is a Load Range C tire size ST175/80R13 mounted on a white spoke wheel with a bolt pattern of 5 on…

view full answer...

Answer 6

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Answer 7

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 8

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 9

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 10

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 11

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 12

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Will The Phoenix Faucets Pop Up Drain Assembly # PF282010 Fit LaSalle Bristol Sink # 34416166PW?

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching