Recommended Hard Tonneau Cover for a 2023 Ford F-350

Question

Question:

Will this folding cover fit a 2023 Ford F-350?

asked by: Jimmy

0

Expert Reply:

It will if your 2023 Ford F-350 has an 8' bed. The BAKFlip F1 Hard Tonneau Cover item # BAK72331 you were looking at is confirmed to fit a 2023 Ford F-350 with an 8' bed. If you truck has the 6-3/4' bed you will need item # BAK72330.

The BaKFlip F1 tonneau cover is made of 5/8" thick fiberglass-reinforced polymer panels that are dent resist and stand up to harsh sunlight. They are compatible with stake-pocket-mounted accessories like ladder racks.

The best part about the BAKFlip F1's is that it can be folded all the way up and remain securely positioned on your truck while you are driving, even at highway speeds.

expert reply by: Jerred H

0

Answer 1

Folding covers have multiple hinges that tend to freeze up in cold, wet conditions so you'd likely have more trouble with folding option, but if your set on wanting a folding cover then I recommend the BAKFlip F1 Hard Tonneau Cover #BAK72331. The…

view full answer...

Answer 2

The BAK Revolver X4s Hard Tonneau Cover #BAK49ZR which fits your 2023 Ford F-350 8' long bed has to be in either the fully rolled up or fully covered position. If you go with a cover like the BAKFlip MX4 Hard Tonneau Cover #BAK48331 you will be…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 5

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 6

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 7

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 8

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 9

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 10

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...