What Gauge Wire Does The 50 Amp Hardwire Cord A10-5025END Use?

Question

Question:

The listing shows this cord has 10 AWG wires, which are only rated for 30 amps. Is that information correct, or was the ground wire size mistakenly reported as being the size for all conductors in the cord? A 6 AWG wire is required for a 50 amp service.

asked by: Kyle L

0

Expert Reply:

I double checked with the manufacturer and you were correct in your assumption. On the 50 amp hardwire cord # A10-5025END, the one ground wire is 10 gauge, the other 3 wires are 6 gauge. I will have our website updated to reflect this. Sorry for any confusion.

expert reply by: Jesse M

0

Answer 1

Unfortunately we do not offer the Furrion Replacement Door #FR73FR in black. Believe me I wish we did have it in black because we get this question all the time. I suppose you could always get one and paint it.

view full answer...

Answer 2

You certainly can switch out the 16" door with an 18" with the Replacement Access Door for Furrion RV Tankless Water Heater - 18" x 18" #FR73FR.

view full answer...

Answer 3

The Mighty Cord Replacement Hardwire RV Power Cord part #A10-5025END is only capable of handling one service so I am not really sure what you mean by separating these out. The wire gauge which is 10 AWG is then sufficient for the singular 50 amp…

view full answer...

Answer 4

Unfortunately we do not offer any other Dometic brand thermostat, other than the #DMC79FR which does use touch buttons. This is actually a known issue with these Dometic thermostats. Removing the face plate usually will allow it to function normally.…

view full answer...

Answer 5

I can confirm that the Advent Air RV Air Conditioner item #ACM150 is designed to replace Dometic ac units like your 57915.341 model. I have linked an installation video below so you can see the process to get this unit installed. It is also available…

view full answer...

Answer 6

Yes, the male side of the Mighty Cord RV Power Cord #A10-5025EDBK is a Nema 14-50 connector.

view full answer...

Answer 7

If you're only wanting to setup AC service in your enclosed trailer then you could choose pretty much any 30 or 50 amp power inlet you wanted and then just run the appropriate gauge wire between the inlet and your panel. You can definitely…

view full answer...

Answer 8

12 KW converted to amps at 125 volts is 55 amps and the Mighty Cord part #A10-5025EDBK is only rated for 50 amps. So while your generator can put out more amperage than needed it would come down to whether or not your entire house would draw more…

view full answer...

Answer 9

All of the SmartPlug RV Power Inlets such as the #SM56FR you were looking at attach directly to the exterior wall of your RV, and there is no box compatible with them. I included a video of this plug being installed for you to take a look at.

view full answer...

Answer 10

The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still cover most of the area you need it…

view full answer...

Answer 11

We do have the Rhino-Rack Masterkey Lock Barrels #RRRK093-2 which will provide you with 2 new lock cores and keys for your Rhino-Rack Zenith MasterFit Rooftop Cargo Box #RRRMFZ66. As far as pricing goes on the different sets they can change based on…

view full answer...

Answer 12

The Solera Gas Strut part #LC280343 is designed for Lippert-Solera branded awnings. That said, it should be able to be used with others but you'd need to verify the dimensions in order to ensure compatibility. The length for this strut will be…

view full answer...