Replacement Grease Seal For a Dexter 3,500LB Axle

Question

Question:

Can you recommend a grease seal for a Dexter 3500 axle? Thanks

asked by: Wayne

1

Helpful Expert Reply:

We have the Grease Seal for your Dexter 3,500lb axle as an Individual # 58846 or Pair # RG06-050. These are double lip seals which are less likely to become damaged and leak out grease or let water in compared to other single lip grease seals.

expert reply by: Bud M

1

Answer 1

I checked with Dexter and the correct bearings you need are the part #L44649 for the inner and outer bearing and for the seal #10-9.

view full answer...

Answer 2

For your 2020 Ford F-150 XLT the best front mount hitch is the Curt #C31083 because it's going to sit just a tad higher than the Draw-Tite alternative for better ground clearance. The 2" receiver for the Curt hitch will actually protrude…

view full answer...

Answer 3

The TruRyde Grease Seals, part #RG06-050 are used on 3,500 lb axles. The inner diameter of the seal is 1.719 inches and the outer diameter is 2.565 inches. If that matches the dimensions of your spindle and your hub, then these will work great for…

view full answer...

Answer 4

To pick out a replacement grease seal you will need to measure the diameter of the spindle where the grease seal rides with a digital or dial caliper and then need to measure the hub bore where the current seal rides. With those two dimensions we can…

view full answer...

Answer 5

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 8

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 9

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 10

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 11

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 12

The modern size equivalent of the 20.5x8-10 that you have currently would be the same size tire that is on the #AM3H340 that you referenced, 205/65-10. As long as the bolt pattern of your current hubs are 4 on 4 inch the wheels of this would bolt up…

view full answer...

Replacement Grease Seal For a Dexter 3,500LB Axle

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching