Will Installing An Advent Air RV Air Conditioner System On A School Bus Void The Warranty

Question

Question:

Do NOT add me to mailing lists. I am thinking about buying 2 ADV94FR. I am installing these units on a converted school bus. They will be installed way better than any RV company will install them. Does this installation pose a concern in the event I have a warantee claim?

asked by: Thomas

0

Expert Reply:

Yes, Advent Air does not warranty any units installed on school buses, food trucks, enclosed/utility trailers, or off-roading vehicles. This means that if you install the Advent Air RV Air Conditioner System # ADV94FR on your converted school bus you would void the manufacturer warranty.

Furrion units do not have this stipulation so you could go with the Furrion Chill HE RV Air Conditioner System # FR95PV or part # FR37FJ for two units that would run off of one thermostat instead.

expert reply by: Kevin C

0

Answer 1

If you have all of this done you are going to have one really nice race trailer! Coin Flooring: The Source #TS59FR 24' long X 8'3/16" wide black vinyl flooring. We do not have interior wall covering for enclosed trailers. For…

view full answer...

Answer 2

The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead to…

view full answer...

Answer 3

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack…

view full answer...

Answer 4

The part you referenced 127194TB is a double-lip seal with an inner diameter of 1.274-inches and an outer diameter of 1.983-inches. The available seal nearest to those dimensions that we offer is part #RG06-010, which is a double-lip seal sold as a…

view full answer...

Answer 5

A TCM double-lip grease seal number 127194 has an inner diameter of 1.274-inches and an outer diameter of 1.983-inches according to my research. The available grease seal nearest to those dimensions that we offer is part #RG06-010, which is a…

view full answer...

Answer 6

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for your…

view full answer...

Answer 7

According to my research, your 92865A-1 hub/drum has a 25580 inner and an 14125A outer bearing and a 8 on 6-1/2 inch lug pattern, as does the AxleTek #AKHD-865-7-2-K hub drum you referenced. The #AKHD-865-7-2-K would be an acceptable replacement for…

view full answer...

Answer 8

I recommend to use the Solera 16-1/2' Slider part #LCV000435661 which matches the boxes width exactly so you will not have side overhang like we normally recommend but it is the biggest slide topper available to fit the 198" width of your…

view full answer...

Answer 9

If you check out the picture I attached you can see that the roller and slide out awning assembly of the Solera RV Slide-Out Awning #LCV000435661 actually will sit below the awning rail so your setup having a tight clearance between the rail and the…

view full answer...

Answer 10

We have toppers that'll work for 2 of your 3 sliders. For your 12 foot 9-1/2 slide, use #LCV000168109 which is designed for slides measuring between 152-157 inches wide. The longest topper we offer is for slides 188-193-3/4 inches, so…

view full answer...

Answer 11

I can definitely help you find the correct replacement hub and bearings for your Dexter P-12 SLR axle, but since part of the serial number was unreadable you will need to take a few simple steps to identify which bearings your axle uses. The easiest…

view full answer...

Answer 12

M12-1.5 and 1/2"-20 threads are not going to be interchangeable. The diameter of an M12 thread is only going to be 0.4724" while 1/2" threads are going to be 0.500" in diameter. We currently only have 1/2"-20 Lug Nuts…

view full answer...

Will Installing An Advent Air RV Air Conditioner System On A School Bus Void The Warranty

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching