Availability Of A Sleeve-Lock Coupler Rated For 16K Or Higher

Question

Question:

Is there a 16k or higher rater version of this coupler?

asked by: Seth

0

Expert Reply:

I do have a potential solution for you, but we do not have a sleeve-lock style coupler rated for 16K or higher. If you are in need of a channel mount coupler for a 2-5/16" ball, we have the # DM15791-81. This will fit in a 3" wide channel bracket, and is rated for 21K

expert reply by: Jesse M

0

Answer 1

For a pin lock that fits as a replacement for the snapper pin of the Curt coupler part #C25329 that you referenced we have the etrailer.com lock part #e98888 which will fit and work well. This will prevent the collar from sliding back to allow the…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 5

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

view full answer...

Answer 6

The three wires of the Tekonsha Breakaway System part #50-85-313 will get wired as follows: The white wire attaches to the ground wire. The blue wire attaches to the brake output circuit that goes to the brake assemblies of the trailer. The black…

view full answer...

Answer 7

The Curt Channel-Mount Coupler part #C25328 is designed to be used with an adjustable channel such as the Curt 3-Position Adjustable Channel Bracket part #C48610 which has an inside width of 3". Therefore, the width of the but end on the coupler…

view full answer...

Answer 8

The Demco 50-Degree A-Frame Coupler without Jack Hole part #DM15349-52 is not available with a jack hole. If you want to add your own hole to accommodate a jack that would be acceptable.

view full answer...

Answer 9

The Timbren Silent Ride #TSR14KT01 can actually be installed by welding it on or bolting it on. You could do both welding and bolt it on, but that is not really necessary. I am not sure of the bracket to move it around on the frame, but they do have…

view full answer...

Answer 10

If there's a conflict in the instructions provided by the RV manufacturer and what's stated by the manufacturer of a sub-assembly such as the #LC1387882 Lippert 1621 pin box, you'll want to go with the advice from the manufacturer of the…

view full answer...

Answer 11

To determine if there are compatible hubs and associated bearings to replace your current hubs to a more standard size you will have to take several precise measurements on the spindle of your axle. It is recommended to use a set of dial calipers to…

view full answer...

Answer 12

Bulldog Collar-Lok Coupler #BD028287 and similar couplers have a sleeve that constantly puts pressure on the front of the coupler, the part that goes around the ball, so that it cannot come loose. There is also more surface area of the coupler making…

view full answer...