Backup Alert for a 2010 Freightliner Sprinter 2500

Question

Question:

Will this work on this model?

asked by: Johnny

0

Expert Reply:

I did a little research and your 2010 Frieghtliner Sprinter 2500 uses a 7506 reverse light bulb. We do not have a bulb replacement with backup alert for the 7506 bulb but I do have a solution for you.

Take a look at Surface Mount Back-up Alarm # BK97DB. You can mount this guy under the vehicle and wire it into a reverse light circuit. It will be louder at 97 decibels and more effective compared to the replacement bulb type. I have included a link to a video showing an installation for you.

expert reply by: Michael H

0

Answer 1

No, you would need 30 amp service in order to fully power the Furrion Chill HE RV Air Conditioner System #FR52PR. If you're boondocking then you'll pretty much be forced to use a generator like #333-0005, unless you had an insanely large…

view full answer...

Answer 2

The Furrion Chill HE RV Air Conditioner System #FR52PR can pull approximately 3,500 watts for a brief second during start up, which would be right at 29.67 amps.

view full answer...

Answer 3

Yes, the Furrion Chill HE RV AC unit part #FR25PR can be powered by a 300 amp hour lithium battery. It draws 11.2 amps when running so your battery setup would easily work fine. The startup amperage is right at 29 amps and it does not have a soft…

view full answer...

Answer 4

The Furrion Chill HE RV Air Conditioner System part #FR52PR will pull up to 20 amps or 2,400 during start up according to Furrion therefore you'll need a slightly larger generator such as the Firman 3,300-Watt Portable RV Dual Fuel Inverter…

view full answer...

Answer 5

There's won't be much of a difference in decibels when switching air conditioner sizes but there is when switching brands. The quietest units we offer are from Furrion, the Furrion Chill HE RV Air Conditioner System part #FR52PR for 13,500…

view full answer...

Answer 6

In order to determine the correct roof vent, measure where the vent opens. The standard trailer roof vent opening is roughly 14-1/4" x 14-1/4" and have roof vents that measure 14" x 14". To pick the correct cover, you will also…

view full answer...

Answer 7

For the front legs of a Lippert Ground Control 3.0 kit the replacement front jack leg solution you'd need is the part #LC362485. This will allow you to reuse your current motor and bracket. There isn't a gear replacement kit for the jack…

view full answer...

Answer 8

Thanks for the pictures of your roof vent lid Marty! Based on that the correct replacement is the Ventline part #BVD0449-A01 that you referenced if you wanted white or the part #BVD0449-A03 for the same smoke color you have now.

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

Hey Paul, we have a Blue Ox base plate kit that fits your 2024 Nissan Versa with the part #BX1856. In addition to the base plates, you will also need a compatible tow bar, safety cables, lighting, and supplemental braking to flat tow your vehicle.…

view full answer...

Answer 11

The 15,000 Btu Furrion air conditioner is what I would recommend and what I have on my trailer. Since it is an enclosed trailer I'm guessing you want the manual distribution box. You can choose from the following based on color: -Furrion Chill HE…

view full answer...

Answer 12

Hey Frankie, The bracket for the Timbren Suspension Enhancement System #TFR250SDJ has a locknut in it that makes it feel like the bolt (part #4) is fully tightened when it's not. Their techs have stated that you just have to push past this point…

view full answer...

Backup Alert for a 2010 Freightliner Sprinter 2500

Products Referenced in This Question

Featured Help Information

Miscellaneous Media

Continue Researching