Available Spare Tire Carriers For a 3"x5" Trailer Tongue

Question

Question:

Hi, I am looking for a spare tire bracket for a 3x5 tounge. I thank you very much.

asked by: Timothy M

0

Expert Reply:

Here are the spare tire carriers we have which will mount to your 3"x5" tongue.

Fulton Hi-Mount Spare Tire Carrier # FHDSTC0101
Extra Offset Trailer Spare Tire Carrier # DL22145
Offset Trailer Spare Tire Carrier # DL22120

These carriers are all slightly different and if you need help selecting the one which will work best for your application please send me an image of where you intend to mount the carrier along with your tire size and bolt pattern.

expert reply by: Bud M

0

Answer 1

As long as you have the necessary clearance on your trailer to fit your spare tire onto this Offset Trailer Spare Tire Carrier, part #DL22120, and you secure it well you should have no problem installing this #DL22120 in any direction that you…

view full answer...

Answer 2

I checked into this with Dutton-Lainson, and the limitation on the #DL22120 offset spare tire has to do with the weight of the 15 inch tire and wheels, and not with the physical size. The welds on the carrier are not rated to handle the weight of…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

For a spare tire carrier that will accommodate a spare tire with a 5 on 5 inch bolt pattern you could use a Trailer Spare Tire Carrier #DL22128. If you are interested in a hitch mounted spare tire carrier for a 2x2 hitch shank I recommend Curt…

view full answer...

Answer 5

If you're getting that much bounce out of your trailer that would lead me to believe that maybe the MORryde IS suspension system is the actual issue. Typically if the suspension is too stiff you'll start to bounce. We see this issue a lot…

view full answer...

Answer 6

I was able to track down some measurements for the 90 degree uprights that are included with the #CE27600K90 bunk kit. Hope this helps. See below: A: Internal Distance - 15-1/2" A: External Distance - 17" B: Internal Distance - 18" B:…

view full answer...

Answer 7

I was able to get the measurements you were looking for of the Draw-Tite front mount hitch that fits your 2020 Toyota Tundra, which is the following: - Draw-Tite Front Mount Trailer Hitch Receiver #65080 The hitch is similar to the Curt #31198 in…

view full answer...

Answer 8

I went out to the warehouse and pulled a CE Smith U-Bolt, part #CE15252A and took some measurements for you. The threaded portion is 2-1/16". The outside width is 4". The outside length is 3-1/8". Check out the photo of the U-Bolt…

view full answer...

Answer 9

The #CE10002G-4 CE Smith Bolster and Swivel is 13" tall. Assuming you mount it at the position to gain the most height, you should have 9" remaining. Losing the height from attaching to the 3" crossmember leaves you with 10"…

view full answer...

Available Spare Tire Carriers For a 3"x5" Trailer Tongue

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching