Mounting Bracket Bolt Hole Pattern For Trailer Valet JXS Trailer Jack # TV34FR

Question

Question:

Mounting Bracket Bolt hole Pattern For Trailer Valet JXS Trailer Jack # TV34FR Do you have specs for the mounting plate on Item # TV34FR? We need to know if the mounting plate will match with our current set of bolt holes. Please and thank you

asked by: Derek

0

Expert Reply:

The mounting bracket for the # TV34FR is actually identical to the bracket on the # TV64FR that you were looking at. The holes are 1" apart on center vertically, and 5-1/2" apart horizontally. I have attached a picture for your reference.

expert reply by: Jesse M

0

TV34FR Bracket
(click to enlarge)

Answer 1

Thank you for the image. It appears you will need either the Demco Channel Tongue Trailer Coupler #DM13203-95 or #DM16080-95. Both of these couplers have a zinc coating for increased corrosion resistance and fit on a standard 3" wide…

view full answer...

Answer 2

Yes, you can use 2 of the Timbren Axle-Less Trailer Suspension Kits #ASR35HDS02 which will give you a total trailer GVWR of 7,000lbs. Do understand you must include the weight of the trailer into this calculation. If you are needing to carry…

view full answer...

Answer 3

The Dutton-Lainson Square Swivel Jack #DL22340 has a mounting plate designed to fit trailer frames with a height of 3" - 5". I have attached a dimensional drawing below with all of the bolt spacing for your reference.

view full answer...

Answer 4

While a lot of wheels have cross compatibility with 1/2"-20 or 9/16"-18 wheel bolts, the Karrier ST235/80R16 Radial Trailer Tire with 16" Aluminum Wheel #KE39JR states that it only works with the 1/2"-20 wheel studs. We do have…

view full answer...

Answer 5

Thanks for the picture. I went ahead and checked out what we have that matches that style of plug, and unfortunately we do not have anything that matches what you are needing. The closest 3-prong wire we have is the 3-Wire Pigtail for Trailer Tail…

view full answer...

Answer 6

The Trailer Valet Jack #TV34FR that you referenced has an inner leg that can travel 14 inches. From the mounting bracket down the jack leg would measure 7 inches at minimum and 21 inches at max.

view full answer...

Answer 7

The B&W Continuum Weight Distribution System part #BW78FR requires at least 24" of space on the frame directly behind the coupler and along the side a few inches back from there. This works with most trailers but for some it will not and,…

view full answer...

Answer 8

There is no wheel add-on specifically for the Trailer Valet JXS Trailer Jack part #TV34FR but there is a similar version of this jack with wheel, the Trailer Valet 5X Swivel Jack and Trailer Mover part #STC-V211 which is what I recommend using. This…

view full answer...

Mounting Bracket Bolt Hole Pattern For Trailer Valet JXS Trailer Jack # TV34FR

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching