What Torque Should Lug Nuts be Torqued to for Kenda Karrier ST175/80R13 with Wheel

Question

Question:

Whats the torque specs on the AM31990 wheel? Thanks

asked by: James F

0

Expert Reply:

Since the trailer wheel and tire # AM31990 is a 13 inch diameter wheel that is steel and designed for 1/2 inch diameter wheel studs the correct lug nut torque is 90-100 ft lbs.

expert reply by: Jameson C

0

Answer 1

I would recommend replacing the tires along with the wheels on your utility trailer. The tires that you currently have on your trailer are passenger car tires which can be identified by the P at the beginning of the tire size and it is not a common…

view full answer...

Answer 2

To select new trailer tires/wheels for your Jayco pop-up camper you'll want to confirm the trailer's axle rating so you can select wheels and tires that have the necessary weight capacity. Usually there will be a sticker or plate on the axle…

view full answer...

Answer 3

It sounds like you are asking if the wheels on your old pop-up camper use the same bolt pattern as the old Ford 5 lug or old Chevy(Holden) 5 lug. If that is the case then I do not know for sure but if I had to take a guess I would say the old Ford 5…

view full answer...

Answer 4

Yes, axle spread and wheel base by definition are the same measurements. You will measure from the center of one axle to the center of the 2nd axle to determine what you axle spread is. This may be difficult as some wheels and covers will make this…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 8

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 9

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 10

Good morning, Cliff. As of today (3/27/24) we are expecting the #KE33JR tire/wheel combo to be in stock in about 2 weeks. Hopefully this means we can take our own pictures and put them on the site within maybe about 3-4 weeks from now. What I can…

view full answer...

Answer 11

The 12 inch tires that we carry are rated for 65 miles per hour. Any faster than that for extended periods and the excessive heat build up will cause tire failure. To get a tire with a higher speed rating you would have to go up in size. That also…

view full answer...

Answer 12

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

What Torque Should Lug Nuts be Torqued to for Kenda Karrier ST175/80R13 with Wheel

Product Page this Question was Asked From

Continue Researching