How Long is the Polar Cam Action Handle On The 45 Long Side-Door Bar Lock Assembly # PLR3057-45?

Question

Question:

How long is the handle? Im looking to replace an existing side door bar. Thanks

asked by: Vincent E

0

Expert Reply:

The Handle # 158-100 for the Polar 45" Long Side-Door Bar Lock Assembly # PLR3057-45 is 14" long and 1-1/4" wide.

expert reply by: Bud M

0

Answer 1

I'll give you a number of different dimensions for the hole spacing as I'm not entirely sure what you were specifically looking for on the 45" Long Side-Door Bar Lock Assembly #PLR3057-45. From the top mounting hole to the bottom…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Yes, the Dexter BrakeRite Electric Over Hydraulic Actuator for Disc Brakes #DX82KR can be used with drum brakes when it's used with the Drum Brake Reducer, but unfortunately the pressure can't be adjusted.

view full answer...

Answer 4

It is possible to use the cam-door lock, #383200, horizontally but it would need to be placed up higher than the midway point to reduce the amount of stress on it when the door is closed. Take a look at the picture I have included that shows this…

view full answer...

Answer 5

From what I have found, the ALKO hub and drum assembly you have is for 7,000 lb axles. I believe the Dexter Trailer Hub and Drum Assembly for 5,200-lb to 7,000-lb Axles - 12" - 8 on 6-1/2 #8-219-4UC3 will work as a replacement. This has the same…

view full answer...

Answer 6

For your 2021 Chevrolet Blazer you're going to need to start with a base plate kit. Since there aren't any Blue Ox base plates I'd recommend going with the Roadmaster Direct-Connect Base Plate Kit #RM-523204-5. These are just as good as…

view full answer...

Answer 7

To replace your NOK AD2527E seal you can use #168233. It has an inner diameter of 1.688 inches and an outer diameter of 2.332 inches. Based on what I could find on the NOK AD2527E the inner diameter is the same and the outer diameter is 2.328 inches.…

view full answer...

Answer 8

From my research, the correct replacement for the UFP HD1377 hub/drum is the Trailer Hub and Drum Assembly part #AKHD-545-35-K or the Dexter 5 on 4-1/2 Complete Hub-and-Drum Assembly part #84546UC3. These hub/drums both use a L68149 (1.378"…

view full answer...

Answer 9

The closest thing we have to a 2" x 2" bumper is the Rubber Bumper for Enclosed Trailer Ramp Door #37210715 you looked at. This has a 2-1/2" diameter with a height of 1" and a 3/8" mounting hole.

view full answer...