Is It Normal For Solera 12V Power Awning to Creak

Question

Question:

I have a Solera automatic awning on my RV unit. Sometimes when I deploy, or retract the awning, the arms sound as though they are creaking. Is this normal or do I need to lubricate the arms with a lubricant?

asked by: David W

1

Helpful Expert Reply:

It is normal for a Solera power awning like # LC405510 to creak sometimes as you deploy or retract the awning.

expert reply by: Kyle S

1

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

Good morning, Cliff. As of today (3/27/24) we are expecting the #KE33JR tire/wheel combo to be in stock in about 2 weeks. Hopefully this means we can take our own pictures and put them on the site within maybe about 3-4 weeks from now. What I can…

view full answer...

Answer 3

The torque for the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles - 12" - 5 Spoke Utility #8-174-5UC3 is not specified by the manufacturer. For 9/16 inch studs, the typical lug nut torque will be 120-140 ft lbs based on most…

view full answer...

Answer 4

You are correct that is a 3,500 lb axle. If you want a bearing kit the #BK2-100 you looked at is the right one. This comes with a #L44649 outer and #L68149 inner bearing along with a #58846 (10-19) grease seal. If you want a replacement idler hub you…

view full answer...

Answer 5

Brien, it sounds like you did your research so kudos to you, but the awning you're looking at is not going to work with the wind sensor. You'd need to use the Solera Smart Arm 12V Power RV Awning #LC517517 instead. You're also going to…

view full answer...

Answer 6

I don't have any recommended installers, but any trusted mechanic should be able to complete the installation for you without too much difficulty. If you're moderately handy, you might even be able to complete the install yourself, as the…

view full answer...

Answer 7

Landing gear jacks have a lead leg and a follower leg. The lead leg is the one the crank goes into. For example if it is the lead leg that is missing then leg #LC179013 is a likely fit. This leg has an outer tube that is 29-1/2 inches tall. The…

view full answer...

Answer 8

If the pitch adjustment isn't staying in place for your Solera Smart Arm 12V Power RV Awning #LC517505 then you'll need to adjust the bolt (B) in the center of the joint to tighten up this function. Attached is a photo showing the location of…

view full answer...

Answer 9

You can check the condition of your hub's races by carefully removing all bearing grease with a rag to expose the actual surface of the races. When they are completely free of grease, etc., inspect them for any signs of scoring (very slight…

view full answer...

Answer 10

Bearing Kit #BK3-100 consists of bearings 15123 and 25580, matching races, grease seal and cotter pin. This kit is intended for a 6K axle. The same component parts are found in Lippert bearing kit 333950, also rated for a 6K axle. Two helpful…

view full answer...

Answer 11

According to my research the correct replacement bearings are parts #25580 and #LM67048 with the replacement seal being part #GS-2250DL. These are available in the Bearing Kit #BK3-300. Just make sure that you have these bearings and that your seal…

view full answer...