Recommended Transmission Quick Disconnect Adapter for a 2016 Jeep Grand Cherokee

Question

Question:

Do you have a transmission oil cooler quick disconnect fit for 2016 Jeep grand Cherokee 3.6 liter. Lines look to be bigger than 3/8 inch ,maybe 1/2 inch?

asked by: Michael K

0

Expert Reply:

I believe what could possibly work for you is the Derale Snap-In Radiator Adapter Fitting for GM # D13035 which measures 2" overall, .48" on the larger flare side, .43" on the smaller end, is .37" in diameter, and has a .27" opening.

I've attached a diagram of this adapter for you to check out as well.

expert reply by: Bryce D

0

Dimensions of # D13035
(click to enlarge)

Answer 1

I went out to the warehouse and pulled a Derale Snap-In Radiator Adapter Fitting, #D13035, to take some measurements for you. The overall length is 2 inches. The larger flare is approximately 0.48 inches in diameter and the smaller flange is 0.43…

view full answer...

Answer 2

For your 2007 Chrysler 300C, the Derale Snap-In Radiator Adapter Fitting for GM #D13035 may fit but I can't confirm it. Most of the transmission coolers come with an insta-dapt radiator adapter like #D13004 that fits most vehicles and has…

view full answer...

Answer 3

The Derale Series 8000 Plate-Fin Transmission Cooler Kit, item #D13504, would be a great choice for your 2007 Chevrolet Silverado. You will also need a Snap-In Radiator Adapter Fitting, item #D13035, to complete the installation on your 6.0 Liter New…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 9

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 10

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

Good morning, Cliff. As of today (3/27/24) we are expecting the #KE33JR tire/wheel combo to be in stock in about 2 weeks. Hopefully this means we can take our own pictures and put them on the site within maybe about 3-4 weeks from now. What I can…

view full answer...

Recommended Transmission Quick Disconnect Adapter for a 2016 Jeep Grand Cherokee

Product Page this Question was Asked From

Continue Researching