What are the Measurements of the Derale Snap-In Radiator Adapter Fitting, # D13035

Question

Question:

what are the measurements on 13035 Derale GM radiator adapter

asked by: Larry P

0

Expert Reply:

I went out to the warehouse and pulled a Derale Snap-In Radiator Adapter Fitting, # D13035, to take some measurements for you.

The overall length is 2 inches. The larger flare is approximately 0.48 inches in diameter and the smaller flange is 0.43 inches in diameter. The diameter of the main body is 0.37 inches. And finally the diameter of the opening on either end is 0.27 inches.

I produced a picture that shows the dimensions for you.

expert reply by: Michael H

0

click to enlarge

Dwayne

7/29/2020

does this adapter work for Dodge caravan or Town & country.?

Reply

Jon G.

8/5/2020

Either of those vehicles should be compatible with a cooler like the Derale Series 8000 # D13503 which comes with the Insta-dapt radiator adapter. This can be found individually as part # D13004.

Reply

Answer 1

I believe what could possibly work for you is the Derale Snap-In Radiator Adapter Fitting for GM #D13035 which measures 2" overall, .48" on the larger flare side, .43" on the smaller end, is .37" in diameter, and has a .27"…

view full answer...

Answer 2

One of my co-workers here happens to have a 2001 Ford Ranger with 4.0 Liter engine and automatic transmission, so I went out and checked under the hood. The transmission lines are located at the drivers side radiator tank, see photo, and run down,…

view full answer...

Answer 3

To install a Derale transmission cooler on your 2010 GMC Canyon you will need one of the Derale Snap-In Radiator Adapter Fitting for GM, #D13035. This will snap into the factory transmission coolers output fitting to allow you to run the coolant line…

view full answer...

Answer 4

The Derale Series 8000 Plate-Fin Transmission Cooler Kit, item #D13504, would be a great choice for your 2007 Chevrolet Silverado. You will also need a Snap-In Radiator Adapter Fitting, item #D13035, to complete the installation on your 6.0 Liter New…

view full answer...

Answer 5

The original transmission cooler line is held in by an E clip. Once you locate the E clip at the radiator housing you will need to push in on the transmission cooler return line, and use a awl or small screwdriver to pry the E clip off of the line.…

view full answer...

Answer 6

The method we use that has proven to be 100 percent reliable for determining which line to use for installing a transmission cooler is to start off with the car totally cooled off. Letting it sit overnight would be ideal. Start the vehicle and put it…

view full answer...

Answer 7

The Derale #D13035 you'd looked at is the fitting you'll need to install a transmission cooler like #D12903 on your 2003 Chevy Silverado 1500. The #D13035 will allow you to install a transmission cooler without cutting the existing…

view full answer...

Answer 8

The best way to pick out a transmission cooler for a vehicle is to go with the largest one available that will fit the available space in front of the radiator. I have attached a drawing that shows the best locations for a transmission cooler. The…

view full answer...

Answer 9

view full answer...

Answer 10

The difference between the plate and fin style, #D13504, and the tube and fin style cooler, #D12904, is that the plate and fin models can cool better than the tube and fin models. You will notice that plate and fin coolers with the same rating as…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

Yes, the Air Lift LoadLifter 5000 Ultimate Air Helper Springs with Internal Jounce Bumpers #AL88211 comes with two separate Schrader valves so that you can air up each air spring individually. If you're also looking for a dual path on-board…

view full answer...

What are the Measurements of the Derale Snap-In Radiator Adapter Fitting, # D13035

Product Page this Question was Asked From

Continue Researching