Will the 50 Amp Circuit Breaker Work on Battery Disconnect for Jayco 5th Wheel Trailer

Question

Question:

Hello will this part work for a 2020 jayco 5th wheel replacement for the 12v 50amp one from the factory in the main battery disconnect for the 12v feed

asked by: Mike B

0

Expert Reply:

The 50 Amp Circuit Breaker part # PK54250PL is just a universal self resetting circuit breaker. It can be used in any application where there is 12V power with a max pull of 50 amps. I don't really know anything about the setup in your trailer but so long as both of the above are true, it should work great for you.

expert reply by: Conner L

0

Answer 1

Yes, the Replacement Lithium Converter for Progressive Dynamics 4500 Series RV Power Control Center #PD4560LICSV is the correct replacement for your PD4560K18LS8 and is designed for use with lithium batteries. Attached is a review video for you to…

view full answer...

Answer 2

The Charge Wizard on the Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger part #PD4575K18LS8 automatically switches voltages while your lead acid battery bank charges. This accelerates the charge but also…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 11

If you are just looking for a new converter, the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers part #PD4635V will be a direct upgrade for the Magnetek Converter Series 6300 Model 6332 that you have now.

view full answer...

Answer 12

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...