1/4" Diameter Locking Pins Which Can Be Keyed Alike

Question

Question:

I am looking for 3- 1/4” pin locks that are keyed the same

asked by: Randy N

0

Expert Reply:

Here is a list of different length 1/4" pin locks we offer which can be keyed alike.

1/2" Long Pin Lock # e98885
7/8" Long Pin Lock # e98890
2" Long Pin Lock # e98886
2-1/2" Long Pin Lock # e98887
3-3/8" Long Pin Lock # e98888

We also have the Adjustable 1/4" Lock # e98883 which can fit from 1/2" to 2-1/2" spans you can get keyed alike as well.

expert reply by: Bud M

0

Answer 1

I went out into our warehouse and pulled a Stainless Steel Trailer Coupler Lock #e98885 and found that the overall diameter of the unit is 1-1/8 inches.

view full answer...

Answer 2

The Master Lock Coupler Lock #2847DAT is not offered keyed alike but other similar coupler locks can be ordered in multiples that can use the same key. The linked page displays all coupler latch locks that are available keyed alike. These are offered…

view full answer...

Answer 3

We sure can, but the Master Lock #605DAT lock you'd looked at isn't available keyed alike. We do have options for keyed alike coupler locks, however. I'd recommend a latch lock such as the etrailer brand #e98890 for a 7/8 inch span or…

view full answer...

Answer 4

Yes, the best way to deter thieves with bolt cutters is to use a very short pin lock in the latch part #e98885. This etrailer.com stainless steel coupler lock only measures a 1/2" span and will not give the thief room to use the bolt cutters to…

view full answer...

Answer 5

We don't have exactly what you're looking for, but I may have a solution for you. The etrailer Trailer Hitch Receiver & Coupler Lockset #e99039 has both a hitch receiver lock and a coupler lock that are keyed alike. However, they are not…

view full answer...

Answer 6

The Master Lock 1-7/8", 2", and 2-5/16" Trailer Coupler Lock #ML377KA is designed to fit most trailer couplers which use a flat lip. You will simply need to measure your coupler lip to ensure it is not more than 5/8" away from the…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

I am sorry I don't have any tires that are going to fit your rim. I do have a couple of comparable size tires that come in a wheel tire combo. I have listed the two below along with their lug patterns. 5 on 4-1/2 Lug Pattern - Kenda 205/65-10…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 12

The Class II Curt Hitch #C12136 and Class II Draw-Tite Hitch #36493 for your 2016 Subaru Outback Wagon are very similar, but every Class I and Class II and some Class III Curt Hitches require stabilizing straps to be used when towing non trailer…

view full answer...

1/4" Diameter Locking Pins Which Can Be Keyed Alike

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching