Wattage Required For 12 Volt Everchill RV Refrigerator WAY44FR

Question

Question:

What is the power draw on your 17 cf model? I need the running amps long with the idle requirements if any. Our ambient temp. Is 72 degrees. I live in an off grid house and are replacing a 30 year old Sun Frost, and have all the meters to read the draw, but need to decide which has the lowest draw. I am trying o compare the ever chill and the Recpro. Thanks

asked by: Wendell H

0

Expert Reply:

Everchill said for the 12 volt Everchill RV Refrigerator # WAY44FR, to run just the fridge they recommend 160 watts and a pair of group 27 batteries.

expert reply by: Kyle S

0

Answer 1

The EverChill #WAY44FR refrigerator only runs on 12 volt DC power. However, when your RV is plugged into 120 volt AC shore power the refrigerator will run automatically from the converter. When you are not plugged into shore power it will run off…

view full answer...

Answer 2

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…

view full answer...

Answer 3

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 4

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching…

view full answer...

Answer 5

There is a suggested and common method for 6 function trailer wiring. You will have the following functions: Right Turn, Left Turn, Ground, Tail/marker, Brake, Battery. I have included a help article on trailer wiring that includes a diagram and…

view full answer...

Answer 6

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights…

view full answer...

Answer 7

From our experiences the Harbor Freight trailers like yours have a hub bore that requires a cap or Bearing Buddy that measures 2.047 inches like the #BB2047 you referenced. We don't have a standard cap that fits this size so the Bearing Buddy…

view full answer...

Answer 8

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5…

view full answer...

Answer 9

On oil bath hubs the seals are different than standard grease seals. The correct replacement for what you have is #91030. Unitized oil seals like this have a part that stays fixed and a part that rotates with the hub for optimum leak protection. I…

view full answer...

Answer 10

Is the battery of the breakaway kit charged? Does your tow vehicle have a brake controller installed?

view full answer...

Answer 11

I spoke with Lippert and they said the Kwikee 35 Series Electric RV 1-Step part #LC3691461 will be a direct replacement for the Coach Steps 725-0041. It will be a bolt-on install for the most part for the exception of changing out the door switch…

view full answer...

Answer 12

I can definitely help you find the correct replacement hub and bearings for your Dexter P-12 SLR axle, but since part of the serial number was unreadable you will need to take a few simple steps to identify which bearings your axle uses. The easiest…

view full answer...

Wattage Required For 12 Volt Everchill RV Refrigerator WAY44FR

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching