Roof Rack With Crossbars Extending Past Feet For 2014 Honda CR-V

Question

Question:

I am looking at your Rhino roof rack RRRVP33 for my 2014 CRV with factory roof rail. Is this the only roof rack system you offer for my car? You show the routing feet for the Thule but I dont see the complete system. On the Rhino unit - when it says the bars are 35 long is that the shorter bar of the two? Do you have a brand where the bars would extend past the mounting pedestals?

asked by: Craig L

0

Expert Reply:

The # RRRVP33 is not the only option for your 2014 Honda CR-V with flush mounted rails. For longer crossbars that extend out further you can use the Rhino Rack Vortex Aero Bar roof rack. You will need the following:

-Rhino-Rack Vortex Aero Crossbars - Aluminum - Black - 49" Long - Qty 2 # RRVA126B-2

-RCL Legs for Rhino-Rack Crossbars and Pioneer Platforms # RRRCL4

-Custom RCP Fit Kit for 4 Rhino-Rack RC and RV Series Roof Rack Legs # RRRCP33-BK

This Vortex Aero is a low-profile crossbar that will reduce drag and wind noise. You will need to choose a set of crossbars listed above based on the color you want. They have an aluminum construction for corrosion resistance, and come with plastic lock cores to deter theft. If you want to upgrade them to metal locks you can add the # RRVA-LEC4.

I have attached a review on a 2016 CR-V below so you can see what the rack will look like installed on your vehicle.

expert reply by: Robin H

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 3

Aside from a slight change in the appearance of the crossbar (the WingBar Evo has some boxed edges as opposed to the completely smooth front of the AeroBlade) the biggest differences are the rubber strip on top of the crossbar and the weight…

view full answer...

Answer 4

For a roof rack to be compatible on your 2020 Jeep Wrangler with Sky One-Touch Power Top, it can't be mounted on the top of the roof and it needs to be high enough for the folding roof to clear. What you need are tall gutter-mounted roof racks.…

view full answer...

Answer 5

Hey Alec, For your 2016 Ford Fusion I recommend the recommend a roof rack from Inno: Inno Aero Crossbars #INXB138-145 Inno Through Feet for Aero Crossbars #INXS250 Custom Fit Kit for Inno XS200, XS250, and INSU-K5 Roof Rack Feet #INK860 As with any…

view full answer...

Answer 6

Hi Alec, The Inno Kayak Roof Rack w/ Tie-Downs #INA452 needs a 28" minimum spread so that the saddles sit at the right spot for the kayak and support the weight properly. This is probably just a general guide from Inno though because the length…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

There are a couple of differences between the two. The JetStream bars like #Y00425 are made of extruded aluminum while the CoreBars such as the #Y00421 you've looked at are constructed of galvanized steel. As you've mentioned, the CoreBar has…

view full answer...

Answer 9

The Rhino-Rack Heavy-Duty Roof Rack Roof Rack have specific C-channels that are designed to fit specific Rhino-Rack Heavy-Duty accessories, like the Rhino-Rack Hi-Lift Jack and Shovel-Holder Brackets #RRRCB-RSHB-RJHB as an example. That's the…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

The Malone Universal Crossbar System #MPG201 is a more economical choice but it still does a good job. The design and quality of Thule's system is why they have such a large difference in price. Whether you go with the Thule Crossroads system…

view full answer...

Answer 12

The Rhino-Rack Roof Rack for Factory Tracks #Y02-490B-NT is going to be your best bet for the tracks on the ARE topper for your 2012 Toyota Tacoma. The weight capacity is 220 lbs like you mentioned, but that's going to be the highest you'll…

view full answer...

Roof Rack With Crossbars Extending Past Feet For 2014 Honda CR-V

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching