Replacement Clear Marker Light For a Glo-Brite 9500c-88

Question

Question:

I am looking for a glo-brite 9500c-88 clear marker light need two. Thank you

asked by: Tim F

0

Expert Reply:

While we do not carry the Glo-Brite 9500c-88 you currently have, we do have a light that will work as a replacement for you. From the information I could find on your Glo-Brite 9500c-88, it measures 2" in diameter.

For the clear light, you would want the Optronics Miro-Flex LED Utility Light # UCL50CB. This light measures 2" in diameter and should fit in your current grommet. You would also need the 2-Wire Pigtail for Optronics Trailer Lights # A46PB. If you want to replace the grommet as well, you would want the 2" Round Grommet # A54GB.

We also have these available in red and amber.

- Miro-Flex LED Clearance or Side Marker Light # MCL50RB (red)
- Miro-Flex LED Clearance or Side Marker Light # MCL50AB (amber)

expert reply by: Scott S

0

Answer 1

I do have options for you but we do not carry the Globrite part 9500-88-BLU. However, based on my research this light has a clear lens with an LED bulb and measures to be 2" in diameter x 1" deep. For a replacement, I recommend using the…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 5

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 11

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...