Replacement 14 x 5.5 5 Lug on 4.5 Rim For Trailer

Question

Question:

Looking for one 1 wheel by Rec Stuff WA408 5545545 in size: 14 x 5.5 5 Lug on 4.5. Any chance you carry this item or know where I can purchase it. Thank you.

asked by: Dave

0

Expert Reply:

I do have a potential option for you, but we do not have an exact match for the wheel you are looking for. We do have The wheel # AM25DR, which is a similar black/silver aluminum wheel. It has a 14 inch diameter and is 5-1/2 inches wide, and has a bolt pattern of 5 on 4-1/2. The rim has a weight capacity of 2,200 pounds. You will also need the Snap-In Valve Stem # AM20903 and the Center Cap # AM90175.

expert reply by: Noah E

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 3

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 4

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 5

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Answer 8

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 9

Hey Jeff, appreciate all the details you provided that was super helpful and we do have the MORryde cushioned pin box that is designed to replace a Lippert Rhino pin box. For the 17,695 lb GVWR you mentioned on the 2024 Brinkley Model Z 3610, what…

view full answer...

Answer 10

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 11

The Access Toolbox Edition Soft, Roll-Up Tonneau Cover #A93VR is designed to fit the youru 2022 Ram 3500 with a 8' dually bed. The Cover #A37FR will only fit an 8' bed with single rear wheels. This is the only difference in these covers is…

view full answer...

Answer 12

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...