Dimensions of the Weld-On Zinc Spring Latch

Question

Question:

Wat is the overall length of pin and size of square part

asked by: Richard H

0

Expert Reply:

The overall length of the pin in the Weld-On Zinc Spring Latch, item # SL58W, is 3-5/8 inches. The Square part is 1-1/2 inches wide by 1-1/4 inches tall by 2 inches long. There are cutouts in the 2 inch long sides that accept the roll pin to hold the latch open when the handle is twisted.

expert reply by: Robert G

0

Answer 1

I went to our warehouse to pull the Redline weld-on spring latch #SL58W to provide you the measurement you are requesting. When the pin is captured, the roll pin will extend 3 millimeters or 0.11 inches. See the diagram I made for you. Also, I…

view full answer...

Answer 2

The 7/16 inch diameter of the pin in the latch pin #SL716SS is on the small side for heavy car trailer ramps. It does not have an official capacity but if it were me I would do with something with a larger diameter. Spring latch #SL58W has a 5/8 inch…

view full answer...

Answer 3

I attached a picture that shows how the #SL58W will install on a trailer with a ramp. I used arrows to point out the latches and the holes that it will fit into when folded up and latched. I also attached a picture that shows where you would weld the…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Dimensions of the Weld-On Zinc Spring Latch

Product Page this Question was Asked From

Continue Researching