What are the Dimensions of Replacement Trailer Hub Wheel Studs # RG03-080

Question

Question:

The part diagram shows a base length D of 1.38, but the picture of the wheel stud shows the base length the same as the spline length. In other words, do the threads go all the way to the spline, or is there an unthreaded space in between?

asked by: John S

1

Helpful Expert Reply:

The pictures for wheel stud set # RG03-080 are more of a typical photo. The actual design is the same as # 165995. I pulled a set from the warehouse to be sure and they are indeed like # 165995.

expert reply by: Michael H

1

Answer 1

A TruRyde rvd-h-865 7k hub/drum like # AKHD-865-7-2-K uses 1/2-inch drive-in studs that are 1-5/16-inches long. For a replacement stud you can use #165981. This is slightly longer at 1-1/2-inches but it has the same 1/2-inch diameter. They are also…

view full answer...

Answer 2

Hey Chris, it sounds like you are asking if the MORryde Suspension Upgrade Kit part #MR46ZR could be used on a trailer that weighs 17,000 lbs. The answer to that is yes it could due to it's heavy duty design although it is not officially weight…

view full answer...

Answer 3

Since your shackle straps are 2-1/4 inch for a wet bolt and heavy duty shackle kit you'd want the #MR46ZR which comes with bushings as well. You do not need new equalizers.

view full answer...

Answer 4

We do not have any wheel studs that match what you are needing exactly. The closest that we have are the Replacement Trailer Hub Wheel Stud #RG03-080 that you have already discovered.

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...