Recommended Front Mounted Hitch for a 2023 Jeep Wrangler Unlimited

Question

Question:

I have a 2023 Jeep Wrangler Unlimited and I am looking to add a front mounted hitch. Which one do you recommend?

asked by: Deanna

0

Expert Reply:

To add a front mounted hitch to your 2023 Jeep Wrangler Unlimited, I recommend the Draw-Tite Front Mount Trailer Hitch item # 65079. This hitch is custom fit and bolts to your Jeep with included hardware.

This front mounted hitch has a 500 lbs capacity for mounting accessories and a 5,000 lbs gross trailer weight. The 2" x 2" receiver sticks out right below the bottom of your front bumper. This receiver will fit with either the factory plastic or steel front bumper.

I have attached a couple of pictures below along with an installation video so you can see what this hitch looks like when installed.

expert reply by: Jerred H

0

Draw-Tite Front Mount Trailer Hitch item # 65079
(click to enlarge)

Answer 1

Yes, there is! To add a hitch to your 2024 Jeep Wrangler Unlimited Rubicon you will want the Draw-Tite item #65079. This front mount hitch is custom fit and bolts to your Jeep with included hardware. It has a 2" receiver that can tow up to a…

view full answer...

Answer 2

There are a couple of pretty big differences between the Draw-Tite Trailer Hitch Receiver #DR64FR and the Curt Trailer Hitch Receiver #CU74FR that fit your 2020 Jeep Gladiator, and I'll go over them so you can decide which trailer hitch is the…

view full answer...

Answer 3

The Draw-Tite Front Mount Trailer Hitch Receiver part #65079 which is a fit for your 2019 Jeep Wrangler Unlimited weighs 20 lbs. I have also attached a photo of what it will look like once installed.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

Hey Mark, so the correct Blue Ox base plate kit to use with the Blue Ox Ascent tow bar part #BX4375. is the part #BLU53FR. For lighting you can use #C96JR, and not have to worry about cutting into the taillight housing as this plugs inline with the…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 11

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 12

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Recommended Front Mounted Hitch for a 2023 Jeep Wrangler Unlimited

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching