Is there a Front Hitch for a 2024 Jeep Wrangler Rubicon?

Question

Question:

Is there a front mount hitch available for a 2024 Jeep Wrangler Rubicon?

asked by: Paul B

0

Expert Reply:

Yes, there is! To add a hitch to your 2024 Jeep Wrangler Unlimited Rubicon you will want the Draw-Tite item # 65079. This front mount hitch is custom fit and bolts to your Jeep with included hardware. It has a 2" receiver that can tow up to a 5,000 lbs trailer or handle up to 500 lbs of accessories like a bike rack or cargo carrier.

I have linked an installation video below to help you get it set up.

expert reply by: Jerred H

0

Answer 1

To add a front mounted hitch to your 2023 Jeep Wrangler Unlimited, I recommend the Draw-Tite Front Mount Trailer Hitch item #65079. This hitch is custom fit and bolts to your Jeep with included hardware. This front mounted hitch has a 500 lbs…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 5

I'm assuming you have hydraulic drum brakes and actually need the brake actuator. If that is the case, you're looking at either extending the tongue so you can bolt on an actuator like the #DX33FR or welding one on like the #DEX94FR. Both…

view full answer...

Answer 6

The closest option that we currently offer to the holder you have pictured would be the Stromberg Carlson Hitching Post Chain and 7-Way Plug Holder for Trailer Jacks #JET-30.

view full answer...

Answer 7

That is correct, the Thule WingBar Evo Crossbars #TH711520 with the Rapid Gutter Feet for Thule Crossbars #TH33ZR does have the static capacity you need to use the rooftop tent like the Thule Tepui Explorer Kukenam 3 Rooftop Tent - 3 Person…

view full answer...

Answer 8

If your side marker lights use 1 wire like the Thinline LED Trailer Clearance or Side Marker Light #MCL67AB then you actually won't route a ground wire to them as they will ground through the mounting hardware. If you are finding a way to…

view full answer...

Answer 9

The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead to stress…

view full answer...

Answer 10

For a 2023 Jeep Wrangler 4XE you'll need the following components: Baseplate: Roadmaster Direct-Connect Base Plate Kit #RM-521453-5. These custom-fit baseplates are designed to work with factory bumpers, if you have an aftermarket bumper please…

view full answer...

Answer 11

Yes, you can replace your weld-on coupler with a bolt-on. You'll just need to drill the holes. Then, if you wanted to go back to a weld-on later that would be fine too. Just to confirm you can check with the trailer's manufacturer that…

view full answer...

Answer 12

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

view full answer...

Is there a Front Hitch for a 2024 Jeep Wrangler Rubicon?

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching