Does The LED Trailer Tail Light with Reflector # 328-003-6019R Need A Gasket

Question

Question:

Does this include a gasket/seal or is one not needed?

asked by: D C

0

Expert Reply:

No the LED Trailer Tail Light with Reflector # 328-003-6019R does not need a gasket for installation. The light has a sealed, waterproof housing and lens which makes the light submersible. The light is rated up to 100,000 hours of operation.

If you have any further questions please feel free to reach back out to me and I will be more than happy to further assist you in your towing endeavors.

expert reply by: Noah E

0

Answer 1

The best option to replace your round 5-1/2 inch tail lights are surface-mounted LEDs because they are going to be the brightest, last the longest, and be the easiest lights to mount. There are two options that are similar except for the lenses,…

view full answer...

Answer 2

I looked up your 2016 Rpod 179 and the #328-003-6019R light looks a lot like what you have. I can't be sure without measuring your light but this one is 5-3/8 inches in total diameter. The mounting holes are also 4-1/8 inches apart on…

view full answer...

Answer 3

The crossbar spread often referred to with roof boxes like #TH6359B or other accessories is measured from center to center. By measuring from the center of the bar to the center of the bar you will get the crossbar spread required for a roof box.…

view full answer...

Answer 4

I recommend getting the Rhino-Rack Heavy-Duty Roof Rack Crossbars #RB1800S-3 over the Vortex Aero Bars #RRVA180B-3 because of the weight capacity. The Heavy Dusty Crossbars come in two colors, silver and black #RB1800B-3 and are 71 inches long with a…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 11

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 12

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Does The LED Trailer Tail Light with Reflector # 328-003-6019R Need A Gasket

Product Page this Question was Asked From

Continue Researching