Replacement Rear Anti-Sway Bar for a 2002 Chevy Tahoe

Question

Question:

Factory rear sway bar broke see attached picture and I am looking for a replacement bar that is a direct fit. I want to use existing holes in frame and not make any modifications.

asked by: Craig

0

Expert Reply:

The Roadmaster rear anti-sway bar # RM-1109-168 replaces the factory bar on your 2002 Chevy Tahoe. There is no drilling or modifications needed to install the new bar. I have included a link to the installation instructions for you.

expert reply by: Michael H

0

click to enlarge

Answer 1

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Answer 2

A drop axle certainly can make it tough to reach the star wheel adjuster on a drum brake. The adjuster spoon tool we offer #W80630 has a 90-degree bend that will often let you get access to the adjuster even on a drop axle. Essentially you will need…

view full answer...

Answer 3

On single axle trailers typically you put the hanger spacing right at 1/4 of an inch shorter than the leaf spring length from eye to eye center. So if you were using the leaf spring part #e54SR that you referenced which measures 25-1/8 inches long…

view full answer...

Answer 4

According to my research, AL-KO 8490 references an AL-KO hub for 3,500 lb axles with a 10 x 2-1/4" drum and a 5 on 4-1/2" bolt pattern. For a drum assembly that will work with these hubs I recommend taking a look at the Electric Trailer…

view full answer...

Answer 5

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

view full answer...

Answer 6

Installing the Union Tee #AL21838 with your #AL57575 will tie the pressure of the two air bags together. So yes, a shift in a very heavy load like a truck camper will potentially result in air being forced from one into the other. The reason I say…

view full answer...

Answer 7

The overall dimensions for the Buyers Products Pintle Hitch Plate w/ ICC Bumper for Chevy/GM 3500 Cab and Chassis #3371809035A are 63" wide x 15.5" tall x 3" deep. If you need any other measurements just let me know.

view full answer...

Answer 8

Your 2000 Chevy 3500 is not considered to be a medium duty truck so Buyers Products Hitch Plate with Pintle Mount #3371809038A would not be the best option for you. For the 3500 we have #3371809035A. But since they have to be welded on and bolted on…

view full answer...

Answer 9

Yes, the Torklift Class V hitch part #TLC1205 would be a great option for your 2002 Chevy Silverado 2500HD long bed. If you instead had a short bed truck you would want the part #TLC1204. The 17k capacity is more than what your truck is rated for so…

view full answer...