Are etrailer Trailer Wheel Locks Keyed Alike or Unique

Question

Question:

Are these all keyed alike? I had a truck bed toolbox a few years ago, and come to find out the manufacturer keyed ALL their toolboxes using the SAME EXACT LOCK. Anybody that has that brand toolbox could use their key to open it. Wanted to make sure the manufacturer of this wheel lock uses unique keys.

asked by: Jon B

0

Expert Reply:

The etrailer Trailer Wheel Lock # 288-02020 is keyed unique. Someone else who has this wheel lock would not be able to use their key to remove this from your tire.

expert reply by: Robin H

0

Answer 1

Yes, the keys from our etrailer.com Coupler Lock, #e98889, and other etrailer.com locks can be replaced if they are lost, but I strongly recommend recording the key number that is stamped on the key. The key number is used for replacement keys, so I…

view full answer...

Answer 2

We do have a set of keyed-alike 5/8" hitch pin locks and trailer coupler locks, which fit standard hitch ball couplers. What you are looking for is the etrailer Hitch Receiver and Coupler Lock Set - 2" Hitch - 1/2" Coupler Latch -…

view full answer...

Answer 3

To select the correct ball mount that will allow you to tow level, you must take two measurements into consideration. First, measure from the ground (on level ground) to the top inside portion of your square hitch receiver opening. Second, measure…

view full answer...

Answer 4

There isn't a way to get a Reese hitch lock with a specific key number on it, so the best we can offer are new, keyed-alike trailer hitch locks, depending on if you need a standard hitch receiver lock, a trailer coupler surround style lock, or a…

view full answer...

Answer 5

We have just what you're looking for with the Gen-Y Anti-Rattle Clamp for 2" Hitch Receivers #GY88XR. The sleeve acts as a wedge to take out play between your hitch receiver and extender. Although it does not not require a wrench and a…

view full answer...

Answer 6

Your 285 series tire is approximately 11.22" wide, so a wheel lock for up to 12" wide tires, like the Club Tire Claw XL Wheel Lock with Lug Nut Protector Plate, part #WI491KA-491LNP that you were looking at should work for you, since the…

view full answer...

Answer 7

The Class II Curt Hitch #C12136 and Class II Draw-Tite Hitch #36493 for your 2016 Subaru Outback Wagon are very similar, but every Class I and Class II and some Class III Curt Hitches require stabilizing straps to be used when towing non trailer…

view full answer...

Answer 8

You certainly can install two pairs of the Ark Drop Down Corner RV Stabilizer Jacks #ARK77FR on your trailer. In that case we recommend adding one jack to each corner of the trailer frame. Keep in mind that these are designed to stabilize, not lift…

view full answer...

Answer 9

For gooseneck trailers like yours where the coupler is not a standard that we have a lock for the best option is going to be a wheel lock like the etrailer part #288-02020, Barb. This will for sure fit as a lock and would be just as effective so it…

view full answer...

Answer 10

The Ark Drop Down Corner RV Stabilizer Jacks #ARK77FR is the XO corner steadies that you're referring to and in the past we were told that there was no weight capacity and that these were simply to be used to help stabilize the trailer. Looking…

view full answer...

Answer 11

Hey Susan, so we don't have any locks designed to lock a gooseneck coupler's inner tube to the outer tube that is welded to the trailer chassis so the best option we have would be a wheel lock like the part #288-02020 which will prevent the…

view full answer...

Answer 12

I do see the Curt Trailer Hitch Receiver #C15845 has been confirmed by Curt to fit your 2024 Ford F-550 Cab and Chassis with a 34" wide frame. For the wiring we do have the Curt T-Connector Vehicle Wiring Harness #C69CR which Curt has also…

view full answer...

Are etrailer Trailer Wheel Locks Keyed Alike or Unique

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching