Does Curt Pintle Hook Fit on B and W Pintle Hook Mounting Plate

Question

Question:

Will these two products work together? BWPMHD14004 C48180 Thanks!

asked by: David

0

Expert Reply:

Yes the Curt Pintle Hook with 1-7/8" Hitch Ball # C48180 does fit on the B&W Pintle Hook Mounting Plate # BWPMHD14004. The pintle hook comes with install hardware too so with these two parts you'd have everything you need.

expert reply by: Jameson C

0

Answer 1

The B&W Pintle Hook Mounting Plate #BWPMHD14004 that you referenced has mounting holes with a 1/2" diameter. I went out to the warehouse and verified this.

view full answer...

Answer 2

Most pintle hitch mounting plates do have the same hole spacing and diameter. That is not to say that there isn't the oddball size every now and again. The vast majority do have the same spacing and hole diameters though so if it were me I would…

view full answer...

Answer 3

You can measure either the outer diameter of the part of the dust cap that fits into the hub OR the inner diameter of the hub where the dust cap goes using calipers such as #PTW80157. Calipers are needed because the measurement has to be as accurate…

view full answer...

Answer 4

I looked up your order notes and it looks like you ordered the Pintle Hook #C48210 and the B and W Plate part #BWPMHD14004. These two parts are compatible with each and will work well for you. The mount has the lower capacity of 16k so that will be…

view full answer...

Answer 5

Yes, you need to be as level as possible to attach a pintle mounting plate like the B&W Pintle Hook Mounting Plate #BWPMHD14004. My recommendation is to ensure you are level; I have added a link below to a help article which details measuring for…

view full answer...

Answer 6

I went out to the warehouse and pulled both B&W pintle mount #BWPMHD14004 and Tow Ready pintle combo #TR63011 and put them together to measure drop. In the lowest position, the drop is 11-1/2 inches. To clarify how I measured, I measured from the…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 10

After you've packed the bearings and assembled everything, carefully slide the hub assembly onto the spindle and install the outer bearing. Install the spindle and tang washer and run the spindle nut down finger tight, then rotate the hub back…

view full answer...

Answer 11

We recommended to repack the wheel bearings on your trailer every 12 months or 12,000 miles. There is not a specific guideline as far as actually replacing the bearings. When repacking them with grease, you will also just want to check for any damage…

view full answer...

Answer 12

Hey Brad, yeah the movement you are seeing is pretty normal. I've played around with enough trailer brake assemblies to know that there is a bit of play in the areas you mentioned when new so what you have is no problem. Since the magnet needs to…

view full answer...