Can You Double Up Battery Leads on the NOCO GENPRO 10x3 On-Board Battery Charger

Question

Question:

Hi, Wondering if I can hook up TWO sets of leads battery 1 leads and battery 2 leads from my NOCO Genpro10x3 to my 8D RV house battery. It seems the 10 Amp charge rate is just not keeping up with demand, but I did not know if this might confuseinch the NOCO, and I certainly do not want to damage it.

asked by: Mark G

0

Expert Reply:

I do have an option for you but doubling up on battery leads with the NOCO GENPRO On-Board Battery Charger part # NOC74FR won't increase the charge rate. The only way to do this would be with a higher rated battery charger, the NOCO GeniusPro Smart Battery Charger part # NOC37FR which has a 25 amp charging rate, 2.5x what you have currently so it will charge the battery much faster. For example, a 100 amp hour battery takes around 7 hours to charge from dead with the Pro10 and only 3 hours with the Pro25. The only downside is that it isn't offered in a 3 bank.

expert reply by: Conner L

0

Answer 1

I checked with Rack'em and the Rack'em Grass Catcher for Toro, Bobcat, and Exmark Lawn Mowers part #RCMMS4-EXS1 will fit an Exmark Metro with 36" deck. It also fits the models with a 48" and 52" deck.

view full answer...

Answer 2

What you would need is the #FHDPW330300. This is a hinge for a 3 by 3 inch trailer tongue. You'd need to have a welder put 1/4 inch spacers above and below the tube so that it fits yours that is only 2-1/2 inches tall.

view full answer...

Answer 3

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 4

To pair the camera and monitor parts of your Furrion Vision S observation camera system #FOS43TASF you can try pressing the button on the bottom of the camera. Please refer to the linked photo. First disconnect power to both camera and monitor…

view full answer...

Answer 5

The NOCO Genius On-Board Battery Charger #329-GEN4 does not have the extensions like the NOCO Accessories X-Connect Extension Cable - 10' Long #329-GC004. If you were to extend the wires from the manufacturer, you would need to so without…

view full answer...

Answer 6

The first thing to check is that the power source you have the Bright Way Switch Mode Battery Charger #BRW77FR is actually producing power. If you have power you should see at least the "Power On" light lit up on the charger. You can also…

view full answer...

Answer 7

The EC code on your Fogatti RV Tankless Water Heater - Gas - Automatic Pilot - 41,800 Btu - Black #LSB44FR means the pilot light tried to ignite but could not due to low gas pressure. If the control panel is displaying error codes then it is working…

view full answer...

Answer 8

A Dexter 8k hub would have an 8 on 6-1/2 inch bolt pattern like what the part #TA45ZR has. This is also a 17.5 inch diameter trailer wheel. For a mod style wheel instead, we have the part #TA35ZR.

view full answer...

Answer 9

First, unless the coupler that you have is not functioning properly, does not couple to the ball, or is damaged, you do not have to change it out. It will still function just fine with electric brakes. I went out to the warehouse to determine the…

view full answer...

Answer 10

Since we do not carry a direct model replacement for your Magnetek 6620 Power Converter, your best option is a full unit replacement. I recommend going with the Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger…

view full answer...