Troubleshooting etrailer/Ram Jack EJ-3520-BBX with Light that Stopped Working

Question

Question:

Light does not work or ram does not work

asked by: Justyn S

0

Expert Reply:

For the etrailer jack part # EJ-3520-BBX we have a replacement light board with the part # EJ-3520-LT and the switch part # EJ-3520-LSW. You might pull your switch out and see if yours is still connected to the wiring properly but most likely it's the switch that's bad since LEDs typically last a really long time.

expert reply by: Jameson C

0

Answer 1

The replacement power switch for your Ram Electric Jack Item #EJ-3520-BBX is Item #EJ-3520-PSW. Links to additional information attached.

view full answer...

Answer 2

For a Ram 3,500 lb jack we have the replacement Light Switch #EJ-3520-LSW and Power Switch #EJ-3520-PSW. If you remove the cover you should be able to then pop the switches out of the head to replace them. There should also be the blade-style wiring…

view full answer...

Answer 3

I have attached a photo you can use to connect the Replacement Power Switch #EJ-3520-PSW to your 3,500 lb RAM jack. We don't have a direct wiring diagram but if you notice even though the wires are the same colors they look pretty different so…

view full answer...

Answer 4

It could be a switch or it could be the wiring to the switch not seating all the way. I would recommend pulling the switch out to see if the wiring is good and if it is then replace the switch with part #EJ-3520-PSW.

view full answer...

Answer 5

If your Ram 3,500 lb. electric jack looks like the Electric Jack w/ Footplate part #EJ-3520-BBX, #EJ-3527-BBX, or #EJ-3520-WBX then the Replacement Power Switch for RAM Electric Trailer Jack with Footplate #EJ-3520-PSW is the correct replacement…

view full answer...

Answer 6

Your RAM jack model ej-3550-bbx will use the Replacement Light Switch #EJ-3520-LSW and Replacement Power Switch #EJ-3520-PSW.

view full answer...

Answer 7

I do have several replacement parts available for the RAM Trailer Jack part #TJD-7000S but not an all inclusive rebuild kit. Instead you will need to select from the components listed below and repair the jack as needed. The most common fault on the…

view full answer...

Answer 8

The Replacement Light Switch #EJ-3520-LSW that you referenced does include the bezel piece you sent in a picture of that's broken on your jack. Whoever you bought this from should cover the replacement since it showed up like this. I checked our…

view full answer...

Answer 9

I am not 100 percent sure what size you need, but a small option for a single-pole rocker switch is the Pollak Universal-Design Rocker Switch #PK34308. This switch is less than an inch wide (15/16") and just under 1-3/4" tall…

view full answer...

Answer 10

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 11

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 12

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Troubleshooting etrailer/Ram Jack EJ-3520-BBX with Light that Stopped Working

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching