Troubleshooting Ram Jack Switch that Doesn't Work all The Time

Question

Question:

I have a Ram RV jacket and when I try and work the up and down toggle, sometimes it works and sometime it does not work. Could this be the switch or the unit itself

asked by: Bernard D

0

Expert Reply:

It could be a switch or it could be the wiring to the switch not seating all the way. I would recommend pulling the switch out to see if the wiring is good and if it is then replace the switch with part # EJ-3520-PSW.

expert reply by: Jameson C

0

Answer 1

If you check out the picture I attached you can see how the wires of the Ram jack switch #EJ-3520-PSW are supposed to be ran to it.

view full answer...

Answer 2

We don't have an install video but basically what you have to do is remove the outer shell of the jack and then squeeze the top and bottom of the switch so that it can push through the mounting hole and then pop the new one in place.

view full answer...

Answer 3

I have attached a photo you can use to connect the Replacement Power Switch #EJ-3520-PSW to your 3,500 lb RAM jack. We don't have a direct wiring diagram but if you notice even though the wires are the same colors they look pretty different…

view full answer...

Answer 4

If your Ram 3,500 lb. electric jack looks like the Electric Jack w/ Footplate part #EJ-3520-BBX, #EJ-3527-BBX, or #EJ-3520-WBX then the Replacement Power Switch for RAM Electric Trailer Jack with Footplate #EJ-3520-PSW is the correct replacement…

view full answer...

Answer 5

If all the wiring on your electric jack is in good condition, and there doesn't seem to be a ground issue, it is likely you simply need to replace the switch itself. For your Ram 3500 Series Jack, the correct replacement switch is part…

view full answer...

Answer 6

I attached a picture that I got from RAM jacks that shows how the RAM Jack switch part #EJ-3520-PSW that you referenced gets wired up.

view full answer...

Answer 7

The replacement power switch for your Ram Electric Jack Item #EJ-3520-BBX is Item #EJ-3520-PSW. Links to additional information attached.

view full answer...

Answer 8

For a Ram 3,500 lb jack we have the replacement Light Switch #EJ-3520-LSW and Power Switch #EJ-3520-PSW. If you remove the cover you should be able to then pop the switches out of the head to replace them. There should also be the blade-style wiring…

view full answer...

Answer 9

I can definitely help! While we do not have access to a complete wiring diagram when installing the Replacement Power Switch #EJ-3520-PSW along with the Replacement Light Board #EJ-3520-LT, we do have an image of the wiring hookup required. Even…

view full answer...

Answer 10

We went ahead and looked up the information regarding your Kedu HY60D switch. For a compatible switch that will work, I recommend the Mini Momentary Switch - On/Off/On - DPDT #37213445. This particular switch has a cutout dimension of 0.745 inch tall…

view full answer...

Answer 11

The correct replacement manual crank handle you need for your RAM Jack is the part #EJ-3520-HD.

view full answer...

Answer 12

Your RAM jack model ej-3550-bbx will use the Replacement Light Switch #EJ-3520-LSW and Replacement Power Switch #EJ-3520-PSW.

view full answer...

Troubleshooting Ram Jack Switch that Doesn't Work all The Time

Product Page this Question was Asked From

Continue Researching