Replacement Plastic Fender For Triton Boat Trailer With Clearance Lights

Question

Question:

I have a older tritton trailer with 13” wheels and amber and red marker lights it has a broken 3 step fender can you help me with that

asked by: Mike M

0

Expert Reply:

It sounds like you are needing a fender like the Fulton Single Axle Trailer Fender with Top and Side Steps # F008573. This step is designed to fit mounting brackets that are spread 28" apart. You can fit Amber # MCL13A2B and Red # MCL13R2B clearance lights on the fender. If you can send me an image of the good fender with measurements for the fender, mounting brackets and lights I can see if we have something that matches exactly what you have.

expert reply by: Bud M

0

Answer 1

Since LED lights do not require a lot of amperage you can go with relatively small wire. Using 16 or 18 gauge wire will be fine. Harness #A20WB uses 20 gauge wire which is on the small side but certainly not a problem at all for LED lights even…

view full answer...

Answer 2

The Optronics clearance light part #MCL95AB is what you are looking for. It's relatively cheap, LED so it will last a very long time, installs easily, and only has one wire for power of it.

view full answer...

Answer 3

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 4

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 5

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 6

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for your…

view full answer...

Answer 7

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

view full answer...

Answer 10

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

view full answer...

Answer 11

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

Answer 12

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Replacement Plastic Fender For Triton Boat Trailer With Clearance Lights

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching