Correct Replacement for Lippert Electric Stabilizer Jack 113407

Question

Question:

Lipert jack LC298707 will it interchange with 113407 ?

asked by: Mario G

0

Expert Reply:

Yes, the Lippert Electric Stabilizer Jack 113407 can be replaced with the Lippert High-Speed Power Stabilizer Jack part # LC298707. It will be a direct bolt-on swap, just simply cut and reattach the new wires and you'll be ready for use.

expert reply by: Conner L

0

Answer 1

I attached a picture that shows the install instructions for the Lippert Components High-Speed Power Stabilizer Jack #LC298707 that you referenced and in it you'll notice a set distance isn't specified for where it has to install on…

view full answer...

Answer 2

Ye the switch is included with the purchase of the Lippert High-Speed Power Stabilizer Jack #LC298707.

view full answer...

Answer 3

Thanks for the photo, and I searched but could not find anything with the numbers on the sticker. Truly, the only way to know which is the correct replacement is to know the model of your Lippert stabilizer jack. There are only a couple that are…

view full answer...

Answer 4

While the two motors do look pretty similar they actually are different and are not interchangeable. The part #LC352338 is not as long and has a wider base whereas the part #LC138445 is a bit longer. The wiring comes out in two different places too.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 8

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 9

Yes, we do. To add a hitch to your 2024 Toyota Grand Highlander, I recommend the Curt Trailer Hitch item #C26VV. This hitch is custom fit and bolts to your Toyota with included hardware. This is a class III hitch with a 2" receiver. It has a…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Correct Replacement for Lippert Electric Stabilizer Jack 113407

Product Page this Question was Asked From

Continue Researching