Where to Find Fuse for Power Steps on Motorhome

Question

Question:

Where is the fuses I’m trying to find a fuse is for my steps

asked by: Thomas O

0

Expert Reply:

The fuse for power steps on a motorhome, like part # LC3658373, will be found on the 12V power wire that runs to your battery bank as opposed to a fuse in the power center like what you find on a vehicle.

What you're looking for is a fuse holder similar to the part # SWC9538 where you can remove a cap to get at the fuse.

Attached is a sample wiring diagram for you to check out. Please note that different steps have different wiring configurations so the location of this fuse can vary for different applications.

expert reply by: Jon G

0

Wiring Diagram
(click to enlarge)

Answer 1

Yes, the switch kit is included with the Lippert Components Kwikee 28 Series Single Electric Step #LC3747452 that you referenced so you would not need to provide it.

view full answer...

Answer 2

While we do not have the ability to pull build sheets from the OEM to identify what part was installed, I think you may have the Lippert Kwikee 28 Series Electric Step #LC3747452. This is a great single step option that is extremely popular as an…

view full answer...

Answer 3

The Replacement Step, Motor, and Control for Kwikee RV Electric Steps part #LC3747452 comes with the Replacement Control Unit for Kwikee Electric RV Steps part #LC379146. Therefore, you&#39;d need to use the included control unit and not an…

view full answer...

Answer 4

A clicking motor on your Tread Lite Electric Double Steps #LC353543 or #LC353621 is indicative there is an issue with the motor not sensing the proper amperage at the end of the extension cycle, which is what tells it to shut off when it is…

view full answer...

Answer 5

Most powered RV steps are wired up so that if you turn on the RV the steps will automatically retract. If yours is extending instead that would indicate that this circuit is wired backwards. Do you know what steps you have?

view full answer...

Answer 6

When installing the transfer switch #342GPTS for your Go Power Weekender ISW RV Solar Charging System #34282183 the generator/shore power should be wired to the N.O. Neutral and N.O. Hot terminals along with the converter charger. The Inverter…

view full answer...

Answer 7

The correct replacement part for your Revolution Kwikee step P/N 1510000140, is the: -Replacement Control Unit for Kwikee 40 Series Electric RV Steps #LC363985. I have included an installation video, preformed on a 2016 Newmar Ventana LE.

view full answer...

Answer 8

The correct replacement control for your 1510000140 step control is the Replacement Control Unit for Kwikee #LC363985. Since most of your functions seem to be working correctly, I would start by checking the 4-way connector before replacing the…

view full answer...

Answer 9

In order to test the motor on what I assume are set of Lippert Kwikee Electric Steps, you will first want to sever the yellow and red wires on the motor. Once you do this you will then need to obtain access to a 12 volt power source you know…

view full answer...

Answer 10

To find the fuse for your Kwikee Electric RV Step Complete Assembly #LC3658373 you'll need to trace the power wire from the switch to the battery. If you think you've found it then you can test continuity of the fuse and replace if…

view full answer...

Answer 11

From the picture you provided it appears you have the Lippert Kwikee 42 Series Double Tread Electric Step #LC372779. Unfortunately, we don't have replacement parts for the steps. Before purchasing make sure the mounting bolt pattern…

view full answer...

Answer 12

The Replacement Control Unit for Kwikee Electric RV Steps #LC379146 which is part 90950600 you referenced is does not have a specific wiring diagram, but I've attached the closest thing and have also included a video of an installation to…

view full answer...