Does Lippert Components Kwikee 28 Series Single Electric Step # LC3747452 Come with Switch Kit

Question

Question:

Is the switch included with the unit?

asked by: Mike

0

Expert Reply:

Yes, the switch kit is included with the Lippert Components Kwikee 28 Series Single Electric Step # LC3747452 that you referenced so you would not need to provide it.

expert reply by: Jameson C

0

Answer 1

The Replacement Step, Motor, and Control for Kwikee RV Electric Steps part #LC3747452 comes with the Replacement Control Unit for Kwikee Electric RV Steps part #LC379146. Therefore, you'd need to use the included control unit and not an existing.…

view full answer...

Answer 2

While we do not have the ability to pull build sheets from the OEM to identify what part was installed, I think you may have the Lippert Kwikee 28 Series Electric Step #LC3747452. This is a great single step option that is extremely popular as an OEM…

view full answer...

Answer 3

The fuse for power steps on a motorhome, like part #LC3658373, will be found on the 12V power wire that runs to your battery bank as opposed to a fuse in the power center like what you find on a vehicle. What you're looking for is a fuse holder…

view full answer...

Answer 4

The awning roller that is installed on the Solera 12V Power RV Awning Conversion Kit #LC434724 that you referenced could be wound too tight and the motor can't overcome the tension. Or it's possible the battery of your RV is weak. Typically…

view full answer...

Answer 5

The Solera Smart Arm 12V Power RV Awnings like part #LC517486 are offered in lengths from 12' to 21'. I have attached a full list of options below. If you can provide the length you need as well as the color I would be glad to make a specific…

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 7

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 8

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 9

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 10

The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still cover most of the area you need it…

view full answer...

Answer 11

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 12

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Does Lippert Components Kwikee 28 Series Single Electric Step # LC3747452 Come with Switch Kit

Product Page this Question was Asked From

Continue Researching