Door Strike Material For The Bauer Products Motorhome Door Lock # BA64FR

Question

Question:

is the strike made of steel or zincthank youconcerned about breakage issues with zinc that i have been reading about.

asked by: Dudley D

0

Expert Reply:

The strike for the Bauer Products Motorhome Door Lock # BA64FR is a zinc plated steel construction.

expert reply by: Kevin C

0

Answer 1

We've actually had this one asked before and have consulted with MaxxAir. Even though you can technically install the MaxxFan Deluxe Roof Vent #MA00-06401K wired to a separate switch, it is not recommended. The reason for this is that their fans…

view full answer...

Answer 2

The correct replacement motor for your LCI motor 366043 on your Kwikee steps is Lippert Components Kwikee Motor and Screws for New IMGL Step Item #LC379147.

view full answer...

Answer 3

Thank you for the pictures of the door latch on your Exiss horse trailer. Based on that the correct replacement is the Bauer #BA64FR that you referenced.

view full answer...

Answer 4

For a vent cover to use with the Ventline E-Z Lift Ventadome #V3092-601-00 so that you can attach to the four mounting brackets of the vent you would want to use one specifically designed for it. For that you would want the MaxxAir Cover part…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 9

There is a trailer hitch receiver as well as a 4-way wiring harness that fit your 2022 Jeep Grand Cherokee WL; that said, we don't have any way to reference a VIN so you'll need to confirm if you do have the WL, which is the new model of…

view full answer...

Answer 10

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 11

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 12

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...