Do MaxxAir MaxxFan RV Roof Vents Come With Wiring Connectors Included

Question

Question:

Do the Maxxfan roof vents come with wire connectors to connect the power?

asked by: David C

0

Expert Reply:

The MaxxFan Plus Roof Vent w/ 12V Fan and Thermostat # MA00-04002K you were looking at comes with 2 butt-connectors for you to be able to splice your vent's wiring to the wiring in your RV. You will want a good pair of crimps # PTW30764 to crimp the ends of the butt-connectors.

expert reply by: Kevin C

0

Answer 1

The MAXX AIR II Vent Cover #MA86JR also listed as part number 00933082 that you referenced does not come with a bug screen built into it nor is there one available for it.

view full answer...

Answer 2

In order to determine the correct roof vent, measure where the vent opens. The standard trailer roof vent opening is roughly 14-1/4" x 14-1/4" and have roof vents that measure 14" x 14". To pick the correct cover,…

view full answer...

Answer 3

The Dometic Ultra Breeze Trailer Roof Vent Cover part #DMC38FR installs using brackets which secure to the vent lid flange. The brackets are screwed into the roof but the cover is attached to the bracket using pins and is easily removeable. I have…

view full answer...

Answer 4

Thanks for the pictures of your roof vent lid Marty! Based on that the correct replacement is the Ventline part #BVD0449-A01 that you referenced if you wanted white or the part #BVD0449-A03 for the same smoke color you have now.

view full answer...

Answer 5

Hey David, we've used the LaSalle Bristol RV Roof Vent install kit part #344270KITW to install several MaxxFan RV roof vents and it's worked well so it would also work well for you. This comes with everything needed so it would be a great…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Hey Paul, we have a Blue Ox base plate kit that fits your 2024 Nissan Versa with the part #BX1856. In addition to the base plates, you will also need a compatible tow bar, safety cables, lighting, and supplemental braking to flat tow your vehicle.…

view full answer...

Answer 8

Hey Frankie, The bracket for the Timbren Suspension Enhancement System #TFR250SDJ has a locknut in it that makes it feel like the bolt (part #4) is fully tightened when it's not. Their techs have stated that you just have to push past this point…

view full answer...

Answer 9

For the front legs of a Lippert Ground Control 3.0 kit the replacement front jack leg solution you'd need is the part #LC362485. This will allow you to reuse your current motor and bracket. There isn't a gear replacement kit for the jack…

view full answer...

Answer 10

The 15,000 Btu Furrion air conditioner is what I would recommend and what I have on my trailer. Since it is an enclosed trailer I'm guessing you want the manual distribution box. You can choose from the following based on color: -Furrion Chill HE…

view full answer...

Answer 11

The two most likely causes of a MaxxAir vent fan lid not opening or closing are either going to be a lift motor or operator failure. I recommend removing the motor and applying power directly to this to see if the shaft turns. If not, you know the…

view full answer...

Answer 12

Most slides have EPDM rubber roofs but because EPDM is rubber it requires treatment each year to keep it soft and prevent shrinkage. You could replace it with TPO which is another synthetic rubber that will last longer than the EPDM. The smallest…

view full answer...

Do MaxxAir MaxxFan RV Roof Vents Come With Wiring Connectors Included

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching